[PATCH v4 7/8] wpa_supplicant: doc: Replace Native Part 1.

[Arowa Suliman]

Replaced the word Native with more inclusive words such as built-in.

Signed-off-by: Arowa Suliman <arowa at chromium.org>
---
 doc/code_structure.doxygen | 2 +-
 doc/driver_wrapper.doxygen | 2 +-
 doc/p2p.doxygen            | 4 ++--
 doc/porting.doxygen        | 2 +-
 wpa_supplicant/ChangeLog   | 2 +-
 5 files changed, 6 insertions(+), 6 deletions(-)

diff --git a/doc/code_structure.doxygen b/doc/code_structure.doxygen
index 3a3b21b72..c7ed5c71a 100644
--- a/doc/code_structure.doxygen
+++ b/doc/code_structure.doxygen
@@ -62,7 +62,7 @@ with with hostapd. The following C files are currently used:
 	Definitions shared by multiple files
 
 \ref l2_packet.h, \ref l2_packet_linux.c, and \ref l2_packet_pcap.c
-	Layer 2 (link) access wrapper (includes native Linux implementation
+	Layer 2 (link) access wrapper (includes built-in Linux implementation
 	and wrappers for libdnet/libpcap). A new l2_packet implementation
 	may need to be added when porting to new operating systems that are
 	not supported by libdnet/libpcap. Makefile can be used to select which
diff --git a/doc/driver_wrapper.doxygen b/doc/driver_wrapper.doxygen
index 66211b3ab..fde256564 100644
--- a/doc/driver_wrapper.doxygen
+++ b/doc/driver_wrapper.doxygen
@@ -27,7 +27,7 @@ documented in \ref driver.h. In addition, a pointer to the 'struct
 \ref wpa_driver_ops' needs to be registered in \ref drivers.c file.
 
 When porting to other operating systems, the driver wrapper should be
-modified to use the native interface of the target OS. It is possible
+modified to use the built-in interface of the target OS. It is possible
 that some extra requirements for the interface between the driver
 wrapper and generic wpa_supplicant code are discovered during porting
 to a new operating system. These will be addressed on case by case
diff --git a/doc/p2p.doxygen b/doc/p2p.doxygen
index d4d86e3ed..475295e94 100644
--- a/doc/p2p.doxygen
+++ b/doc/p2p.doxygen
@@ -274,8 +274,8 @@ for removing the group interface for the failed group.
 P2P protocol includes service discovery functionality that can be used
 to discover which services are provided by the peers before forming a
 group. This leverages the Generic Advertisement Service (GAS) protocol
-from IEEE 802.11u and P2P vendor-specific contents inside the Native
-GAS messages.
+from IEEE 802.11u and P2P vendor-specific contents inside the GAS 
+messages.
 
 The P2P module takes care of GAS encapsulation, fragmentation, and
 actual transmission and reception of the Action frames needed for
diff --git a/doc/porting.doxygen b/doc/porting.doxygen
index b4b78ef05..2144a4053 100644
--- a/doc/porting.doxygen
+++ b/doc/porting.doxygen
@@ -21,7 +21,7 @@ most targets. However, couple of additional functions that are common
 on modern UNIX systems are used. Number of these are listed with
 prototypes in \ref common.h (the \verbatim #ifdef CONFIG_ANSI_C_EXTRA \endverbatim
 block). These functions may need to be implemented or at least defined
-as macros to native functions in the target OS or C library.
+as macros to built-in functions in the target OS or C library.
 
 Many of the common ANSI C functions are used through a wrapper
 definitions in \ref os.h to allow these to be replaced easily with a
diff --git a/wpa_supplicant/ChangeLog b/wpa_supplicant/ChangeLog
index a06a93b22..34318f489 100644
--- a/wpa_supplicant/ChangeLog
+++ b/wpa_supplicant/ChangeLog
@@ -1864,7 +1864,7 @@ ChangeLog for wpa_supplicant
 	  generate, e.g., man pages
 	* l2_packet_linux: use socket type SOCK_DGRAM instead of SOCK_RAW for
 	  PF_PACKET in order to prepare for network devices that do not use
-	  Ethernet headers (e.g., network stack with native IEEE 802.11 frames)
+	  Ethernet headers (e.g., network stack with original IEEE 802.11 frames)
 	* use receipt of EAPOL-Key frame as a lower layer success indication
 	  for EAP state machine to allow recovery from dropped EAP-Success
 	  frame
-- 
2.32.0.402.g57bb445576-goog