Scan request looks ignored when wpa_state is in scanning state with dbus interface

[Jouni Malinen]

On Wed, Feb 24, 2016 at 05:27:09PM +0530, Johncy Bennette wrote:
> I am using wpa_supplicant + dbus to connect my device to Access point,
> scan access points, disconnect from access points. If I send a scan
> command, when there is a problem connecting to the access points, My
> scan list is empty.
> 
> The sequence is as below,
> 
> My device connected to a access point successfully.
> After a while, switched off the access point, and my software tries to
> reconnect when there is a disconnect signal at 30 seconds interval
> (unless user has disabled wifi). At this period if I try to scan the
> wifi networks my scan list is empty.
> When i send wpa_cli -iwlan0 status it shows the wpa_state as SCANNING.
> I could see there is no scan_done signal received from dbus with dbus-monitor

Could you please share a wpa_supplicant debug log with -dt on command
line showing this?

-- 
Jouni Malinen                                            PGP id EFC895FA