Hostapd and MCS rates

[Krishna Chaitanya]

On Fri, Jun 19, 2015 at 12:05 PM, Mathieu Slabbinck
<matty.slabbinck at gmail.com> wrote:
> In the .config I can see that:
> ./.config:CONFIG_MAC80211_RC_MINSTREL=y
> ./.config:CONFIG_MAC80211_RC_MINSTREL_HT=y
> ./.config:CONFIG_ATH9K_LEGACY_RATE_CONTROL=y
>
> no VHT but that should not be an issue right?
> I'll create the setup and try to set it to capture some packets again.
> But I doubt it's the sniffer, I'm thinking more into
> configuration/compilation.
Please use bottom posting.
Hmm..so both minstrel and ath9k_rc are enabled, assuming mac80211
module param is used? So i suspect that ath9k_legacy_rc is not
honoring
the iw's request, can you try disabling that use minstrel_ht?