Hostapd and MCS rates

[Mathieu Slabbinck]

In the .config I can see that:
./.config:CONFIG_MAC80211_RC_MINSTREL=y
./.config:CONFIG_MAC80211_RC_MINSTREL_HT=y
./.config:CONFIG_ATH9K_LEGACY_RATE_CONTROL=y

no VHT but that should not be an issue right?
I'll create the setup and try to set it to capture some packets again.
But I doubt it's the sniffer, I'm thinking more into
configuration/compilation.

Kr

On Fri, Jun 19, 2015 at 8:21 AM, Krishna Chaitanya
<chaitanya.mgit at gmail.com> wrote:
> On Fri, Jun 19, 2015 at 11:20 AM, Mathieu Slabbinck
> <matty.slabbinck at gmail.com> wrote:
>> I'm using Ath9k. Not really specifying the rate control algorithm. How
>> can I verify this?
> Can you please check the .config for below RC algos?
> CONFIG_MAC80211_RC_MINSTREL
> CONFIG_MAC80211_RC_MINSTREL_HT
> CONFIG_MAC80211_RC_MINSTREL_VHT
>
> ATH9K_LEGACY_RATE_CONTROL
>
> I doubt that the above is enabled as its default N
> and needs input to ma80211 module loading.
>
> Also may be you can share the sniffer capture?
> It might not show the rate info properly?