Scan in AP mode

[Drasko DRASKOVIC]

Hi all,
Is possible to scan the network for oter APs when card is in AP mode?

Here are my ifconfig and iwconfig outputs :

root at master:~/nasWifi# ifconfig
eth0      Link encap:Ethernet  HWaddr 00:1f:7b:b0:02:e1
          inet addr:10.0.1.32  Bcast:10.0.1.255  Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:10685 errors:0 dropped:31 overruns:0 frame:0
          TX packets:294 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:1781467 (1.7 MB)  TX bytes:26989 (26.9 KB)

lo        Link encap:Local Loopback
          inet addr:127.0.0.1  Mask:255.0.0.0
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:0 (0.0 B)  TX bytes:0 (0.0 B)

mon.wlan0 Link encap:UNSPEC  HWaddr
10-6F-3F-7A-AE-AE-00-00-00-00-00-00-00-00-00-00
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:31151 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:5422408 (5.4 MB)  TX bytes:0 (0.0 B)

wlan0     Link encap:Ethernet  HWaddr 10:6f:3f:7a:ae:ae
          inet addr:10.0.0.1  Bcast:10.0.0.255  Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:164657 errors:0 dropped:23 overruns:0 frame:0
          TX packets:150800 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:246872988 (246.8 MB)  TX bytes:229417608 (229.4 MB)

root at master:~/nasWifi# iwconfig
lo        no wireless extensions.

eth0      no wireless extensions.

wlan0     IEEE 802.11abgn  Mode:Master  Frequency:2.442 GHz  Tx-Power=20 dBm
          Retry  long limit:7   RTS thr:off   Fragment thr:off
          Power Management:off

mon.wlan0  IEEE 802.11abgn  Mode:Monitor  Tx-Power=20 dBm
          Retry  long limit:7   RTS thr:off   Fragment thr:off
          Power Management:off




However, if I try to scan :

root at master:~/nasWifi# iwlist wlan0 scan
wlan0     Interface doesn't support scanning : Operation not supported


Best regards,
Drasko