RSN Pre-authentication issue
Harshil Anil Kumar Shah
Sun May 1 23:52:41 PDT 2011
Hey guys, please give some input.
I am trying to do RSN pre-authentication. Following is my setup and configuration.
Server ========= AP2==========AP1------------mobile
Following is my hostapd.conf on both APs with difference shown.
interface = ath0
own_ip_addr=192.168.1.2 (both IPs are different)
So when I execute following on mobile:
./preauth_test wpa_supplicant.conf <MAC of AP2> wlan0
It shows no receiving of packets on AP1.
Where am I going wrong?
Thanks and Regards,
Convergence Lab, Infosys Labs,
Infosys Technologies Limited | Bangalore
Mob # : +91 97428 87966.
**************** CAUTION - Disclaimer *****************
This e-mail contains PRIVILEGED AND CONFIDENTIAL INFORMATION intended solely
for the use of the addressee(s). If you are not the intended recipient, please
notify the sender by e-mail and delete the original message. Further, you are not
to copy, disclose, or distribute this e-mail or its contents to any other person and
any such actions are unlawful. This e-mail may contain viruses. Infosys has taken
every reasonable precaution to minimize this risk, but is not liable for any damage
you may sustain as a result of any virus in this e-mail. You should carry out your
own virus checks before opening the e-mail or attachment. Infosys reserves the
right to monitor and review the content of all messages sent to or from this e-mail
address. Messages sent to or from this e-mail address may be stored on the
Infosys e-mail system.
***INFOSYS******** End of Disclaimer ********INFOSYS***
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Hostap