RSN Pre-authentication issue

Harshil Anil Kumar Shah Harshil_Shah
Fri Apr 29 04:42:40 PDT 2011

Hi Jouni,

I am trying to do RSN pre-authentication. Following is my setup and configuration.

Server ========= AP2==========AP1------------mobile
                                   (hostapd)                (hostapd)

Following is my hostapd.conf on both APs with difference shown.

interface = ath0
own_ip_addr= (both IPs are different)


So when I execute following on mobile:

./preauth_test  wpa_supplicant.conf <MAC of AP2> wlan0

It shows no receiving of packets on AP1.

Where am I going wrong?

Thanks and Regards,
Harshil Shah,
Convergence Lab, Infosys Labs,
Infosys Technologies Limited | Bangalore
Mob # : +91 97428 87966.

**************** CAUTION - Disclaimer *****************
This e-mail contains PRIVILEGED AND CONFIDENTIAL INFORMATION intended solely 
for the use of the addressee(s). If you are not the intended recipient, please 
notify the sender by e-mail and delete the original message. Further, you are not 
to copy, disclose, or distribute this e-mail or its contents to any other person and 
any such actions are unlawful. This e-mail may contain viruses. Infosys has taken 
every reasonable precaution to minimize this risk, but is not liable for any damage 
you may sustain as a result of any virus in this e-mail. You should carry out your 
own virus checks before opening the e-mail or attachment. Infosys reserves the 
right to monitor and review the content of all messages sent to or from this e-mail 
address. Messages sent to or from this e-mail address may be stored on the 
Infosys e-mail system.
***INFOSYS******** End of Disclaimer ********INFOSYS***
-------------- next part --------------
An HTML attachment was scrubbed...

More information about the Hostap mailing list