P2P connect doesn't work

[Fabien Marotte]

Hi Jouni,

On 10/09/2010 06:39 AM, Jouni Malinen wrote:
> On Fri, Oct 08, 2010 at 06:26:35PM +0200, Fabien Marotte wrote:
>
>> However, when I do "p2p_connect<mac adddr>  pin" or even "p2p_connect
>> <mac adddr>  pbc", the P2P GO negotiation fails.
>
>> I decoded the GO negotiation response and saw that STATUS ATTRIBUTE
>> contains 0x1: From the p2p spec, 0x1 is "FAILED; Information is
>> currently unavailable"
>
> Did you run p2p_connect command on both devices? This code 1 is expected
> behavior when you have not accepted the connection on the recipient.
> Once you enter matching p2p_connect on that device, the connection
> should be formed (i.e., you will see another GO Negotiation going
> through at that point).
>
Ok, I tested on my setup and p2p_connect on both side works. However is 
there a way to configure wpa_supplicant in order to accept connections 
without any user interaction? For example in a context where 
wpa_supplicant is embedded in an system like a TV or a projector ?

Regards,

Fabien