Problem on using the binary for windows

Jouni Malinen j
Thu Mar 27 10:29:22 PDT 2008


On Fri, Mar 28, 2008 at 01:05:48AM +0800, Jack Yip wrote:

> to verify that if wpa_supplicant_0.6.3 is working well in EAP-FAST  with the Cisco AP with built-in server.
> 
> But after I install Winpcap, and enter instuction in command prompt,I found the following:

> Line 616: unknown EAP method 'IKEV2'
> You may need to add support for this EAP method during wpa_supplicant
> build time configuration.

> Do I need to append the wpa_supplicant.conf ?

Yes, the example configuration file has many network entries that may
not be supported by the Windows binary version. It would probably be
simpler to just start from an empty file and add a suitable network
block for the AP.

-- 
Jouni Malinen                                            PGP id EFC895FA



More information about the Hostap mailing list