Authentication timeout with wext driver and ipw3945 card

Giuliano Pasqualotto giuliano.pasqualotto
Thu Jan 17 00:14:44 PST 2008 

Hi everyone,
I've seen the same problem more time in this mailing list, but I'm not able
to understand how could I resolve it. :-)
Well, I've installed an Intel ipw3945 in my Slackware 12 and it works
correctly (without authentication WEP WPA etc.).
After that I've built and installed wpa_supplicant 0.5.9., and tried to
launch with this "classical" configuration file:

ctrl_interface=/var/run/wpa_supplicant
ap_scan=0
network={
        ssid="alegigijacopogiulio...ntwk!"
        proto=WPA
        key_mgmt=WPA-PSK
        pairwise=CCMP TKIP
        group=CCMP TKIP WEP104 WEP40
        psk=my_psk_in_hex
        priority=5
}

Now, running wpa_supplicant (with: wpa_supplicant -eth1 -Dwext
-c/etc/wpa_supplicant.conf -dd) it initially authenticates,
but after some seconds it says me:
        ...
        Authentication with 00:1b:11:86:d7:8a timed out.
        Added BSSID 00:1b:11:86:d7:8a into blacklist
        wpa_driver_wext_disassociate
        ...

and I'm not able to obtain an IP address using dhcp (consequently?).
I've checked /var/log/messages, syslog (without infos), and dmesg that says
me:
        ...
        eth1: no IPv6 routers present
        ...

Anyone could help me? Below I've pasted the output of wpa_supplicant.
Thank's in advance!

Initializing interface 'eth1' conf '/etc/wpa_supplicant.conf' driver
'default' ctrl_interface 'N/A' bridge 'N/A'
Configuration file '/etc/wpa_supplicant.conf' -> '/etc/wpa_supplicant.conf'
Reading configuration file '/etc/wpa_supplicant.conf'
ctrl_interface='/var/run/wpa_supplicant'
ctrl_interface_group='0' (DEPRECATED)
ap_scan=0
Line: 22 - start of a new network block
ssid - hexdump_ascii(len=27):
     61 6c 65 67 69 67 69 6a 61 63 6f 70 6f 67 69 75   alegigijacopogiu
     6c 69 6f 2e 2e 2e 6e 74 77 6b 21                  lio...ntwk!
proto: 0x1
key_mgmt: 0x2
pairwise: 0x18
group: 0x1e
PSK - hexdump(len=32): [REMOVED]
priority=5 (0x5)
Priority group 5
   id=0 ssid='alegigijacopogiulio...ntwk!'
Initializing interface (2) 'eth1'
EAPOL: SUPP_PAE entering state DISCONNECTED
EAPOL: KEY_RX entering state NO_KEY_RECEIVE
EAPOL: SUPP_BE entering state INITIALIZE
EAP: EAP entering state DISABLED
EAPOL: External notification - portEnabled=0
EAPOL: External notification - portValid=0
SIOCGIWRANGE: WE(compiled)=22 WE(source)=16 enc_capa=0xf
  capabilities: key_mgmt 0xf enc 0xf
WEXT: Operstate: linkmode=1, operstate=5
Own MAC address: 00:18:de:13:99:fe
wpa_driver_wext_set_wpa
wpa_driver_wext_set_key: alg=0 key_idx=0 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=1 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=2 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=3 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_countermeasures
wpa_driver_wext_set_drop_unencrypted
Setting scan request: 0 sec 100000 usec
ctrl_interface_group=0
Added interface eth1
RTM_NEWLINK: operstate=0 ifi_flags=0x1002 ()
Wireless event: cmd=0x8b06 len=8
RTM_NEWLINK: operstate=0 ifi_flags=0x1003 ([UP])
RTM_NEWLINK, IFLA_IFNAME: Interface 'eth1' added
RTM_NEWLINK: operstate=0 ifi_flags=0x1003 ([UP])
RTM_NEWLINK, IFLA_IFNAME: Interface 'eth1' added
RTM_NEWLINK: operstate=0 ifi_flags=0x11003 ([UP][LOWER_UP])
RTM_NEWLINK, IFLA_IFNAME: Interface 'eth1' added
RTM_NEWLINK: operstate=0 ifi_flags=0x11003 ([UP][LOWER_UP])
Wireless event: cmd=0x8b15 len=20
Wireless event: new AP: 00:1b:11:86:d7:8a
State: DISCONNECTED -> ASSOCIATED
wpa_driver_wext_set_operstate: operstate 0->0 (DORMANT)
WEXT: Operstate: linkmode=-1, operstate=5
Associated to a new BSS: BSSID=00:1b:11:86:d7:8a
No keys have been configured - skip key clearing
Network configuration found for the current AP
WPA: No WPA/RSN IE available from association info
WPA: Set cipher suites based on configuration
WPA: Selected cipher suites: group 30 pairwise 24 key_mgmt 2 proto 1
WPA: clearing AP WPA IE
WPA: clearing AP RSN IE
WPA: using GTK CCMP
WPA: using PTK CCMP
WPA: using KEY_MGMT WPA-PSK
WPA: Set own WPA IE default - hexdump(len=24): dd 16 00 50 f2 01 01 00 00 50
f2 04 01 00 00 50 f2 04 01 00 00 50 f2 02
EAPOL: External notification - EAP success=0
EAPOL: External notification - EAP fail=0
EAPOL: External notification - portControl=Auto
Associated with 00:1b:11:86:d7:8a
WPA: Association event - clear replay counter
EAPOL: External notification - portEnabled=0
EAPOL: External notification - portValid=0
EAPOL: External notification - EAP success=0
EAPOL: External notification - portEnabled=1
EAPOL: SUPP_PAE entering state CONNECTING
EAPOL: SUPP_BE entering state IDLE
Setting authentication timeout: 10 sec 0 usec
Cancelling scan request
EAPOL: startWhen --> 0
EAPOL: SUPP_PAE entering state CONNECTING
EAPOL: txStart
WPA: drop TX EAPOL in non-IEEE 802.1X mode (type=1 len=0)
Authentication with 00:1b:11:86:d7:8a timed out.
Added BSSID 00:1b:11:86:d7:8a into blacklist
wpa_driver_wext_disassociate
No keys have been configured - skip key clearing
State: ASSOCIATED -> DISCONNECTED
wpa_driver_wext_set_operstate: operstate 0->0 (DORMANT)
WEXT: Operstate: linkmode=-1, operstate=5
EAPOL: External notification - portEnabled=0
EAPOL: SUPP_PAE entering state DISCONNECTED
EAPOL: SUPP_BE entering state INITIALIZE
EAPOL: External notification - portValid=0
EAPOL: External notification - EAP success=0
Setting scan request: 0 sec 0 usec
RTM_NEWLINK: operstate=0 ifi_flags=0x1003 ([UP])
Wireless event: cmd=0x8b15 len=20
Wireless event: new AP: 00:00:00:00:00:00
Added BSSID 00:00:00:00:00:00 into blacklist
CTRL-EVENT-DISCONNECTED - Disconnect event - remove keys
wpa_driver_wext_set_key: alg=0 key_idx=0 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=1 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=2 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=3 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=0 set_tx=0 seq_len=0 key_len=0
State: DISCONNECTED -> DISCONNECTED
wpa_driver_wext_set_operstate: operstate 0->0 (DORMANT)
WEXT: Operstate: linkmode=-1, operstate=5
EAPOL: External notification - portEnabled=0
EAPOL: External notification - portValid=0
EAPOL: External notification - EAP success=0
RTM_NEWLINK: operstate=0 ifi_flags=0x1003 ([UP])
RTM_NEWLINK, IFLA_IFNAME: Interface 'eth1' added


-- 
I disapprove of what you say, but I will defend to the death your right to
say it.
Voltaire
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.shmoo.com/pipermail/hostap/attachments/20080117/1848f8ab/attachment.htm

More information about the Hostap mailing list