hostap and bonded interfaces

[dragondaddy at hushmail.com]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Hello all.

   I have searched the archives going back a year and found nothing
about this.

  I would like to bond two 802.11g cards and have them each on a
different channel, namely 6 and 11.  But I think the only way that
I can get an access point to recognize that it is getting a bonded
signal is to bond the access points.  So I was wondering if I
bonded two cards that would give me bond0 as in interface could I
then apply hostap to that interface?  Bonding seems to be the only
way I can increase my through put.  If I get complete bonding I
should get somewhere near 108mbs, but I doubt it will be complete
I'd be happy with 75 mbs.  But is this possible?

  Maybe I'm barking up the wrong tree. If there is a better way to
do it then use hostap would you be so kind as to point me in that
direction.

Thanks
Joe.
-----BEGIN PGP SIGNATURE-----
Charset: UTF8
Version: Hush 3.0
Note: This signature can be verified at https://www.hushtools.com/verify

wkYEARECAAYFAklDjWsACgkQWxjNVzInnhW/RQCcCzfAf9FnmI6ygJkLRXBsy81cDnoA
n2fYCTWtLzSjvXNp7dWrDY/VsiLk
=YZhY
-----END PGP SIGNATURE-----