WPA - AP association Issue

[Mr. Maloomnahi]

Hi Bryan,

Thanks again for the suggestions. I have annexed the dump below after testing with the latest code.

The firmware related code which I mentioned is precisely only for firmware based scanning and association and I do not use them if I have to run the WPA Supplicant Src Code. 

As far as the extra prints are concerned I can see them now. So is this a hostapd Src code issue or configuration file issue?

==============
[root at chandrasekhar wpa_supplicant-0.5.8]# ifconfig ath0 192.168.1.152 up                                                     [root at chandrasekhar wpa_supplicant-0.5.8]# iwconfig ath0 key DEAD-BEEF-AA open                                                [root at chandrasekhar wpa_supplicant-0.5.8]# ./wpa_supplicant -Dmadwifi -iath0 -c /home/prashant/authenticator/wpa_supplicant-0.5.8/EAP_TLS.conf -ddd
Initializing interface 'ath0' conf '/home/prashant/authenticator/wpa_supplicant-0.5.8/EAP_TLS.conf' driver 'madwifi' ctrl_interface 'N/A' bridge 'N/A'
Initializing interface (2) 'ath0'
EAPOL: SUPP_PAE entering state DISCONNECTED
EAPOL: KEY_RX entering state NO_KEY_RECEIVE
EAPOL: SUPP_BE entering state INITIALIZE
EAP: EAP entering state DISABLED
EAPOL: External notification - portEnabled=0
EAPOL: External notification - portValid=0
SIOCGIWRANGE: WE(compiled)=20 WE(source)=13 enc_capa=0xf
  capabilities: key_mgmt 0xf enc 0xf
WEXT: Operstate: linkmode=1, operstate=5
Own MAC address: 00:14:78:8f:73:1f
wpa_driver_madwifi_del_key: keyidx=0
wpa_driver_madwifi_del_key: keyidx=1
wpa_driver_madwifi_del_key: keyidx=2
wpa_driver_madwifi_del_key: keyidx=3
wpa_driver_madwifi_set_countermeasures: enabled=0
wpa_driver_madwifi_set_drop_unencrypted: enabled=1
Setting scan request: 0 sec 100000 usec
Added interface ath0
RTM_NEWLINK: operstate=0 ifi_flags=0x1003 ([UP])
Wireless event: cmd=0x8b06 len=8
RTM_NEWLINK: operstate=0 ifi_flags=0x1003 ([UP])
Wireless event: cmd=0x8b19 len=8
Received 777 bytes of scan results (3 BSSes)
Scan results: 3
AP count: 3
num_prio: 0
No suitable AP found.
Setting scan request: 5 sec 0 usec
RTM_NEWLINK: operstate=0 ifi_flags=0x11003 ([UP][LOWER_UP])
Wireless event: cmd=0x8b15 len=20
Wireless event: new AP: 00:14:78:8f:5e:49
State: DISCONNECTED -> ASSOCIATED
wpa_driver_wext_set_operstate: operstate 0->0 (DORMANT)
WEXT: Operstate: linkmode=-1, operstate=5
Associated to a new BSS: BSSID=00:14:78:8f:5e:49
No keys have been configured - skip key clearing
No network configuration found for the current AP
wpa_driver_madwifi_disassociate
No keys have been configured - skip key clearing
State: ASSOCIATED -> DISCONNECTED
wpa_driver_wext_set_operstate: operstate 0->0 (DORMANT)
WEXT: Operstate: linkmode=-1, operstate=5
EAPOL: External notification - portEnabled=0
EAPOL: External notification - portValid=0
RTM_NEWLINK: operstate=0 ifi_flags=0x11003 ([UP][LOWER_UP])
RTM_NEWLINK, IFLA_IFNAME: Interface 'ath0' added
RTM_NEWLINK: operstate=0 ifi_flags=0x1003 ([UP])
Wireless event: cmd=0x8b15 len=20
Wireless event: new AP: 00:00:00:00:00:00
Added BSSID 00:00:00:00:00:00 into blacklist
CTRL-EVENT-DISCONNECTED - Disconnect event - remove keys
wpa_driver_madwifi_del_key: keyidx=0
wpa_driver_madwifi_del_key: keyidx=1
wpa_driver_madwifi_del_key: keyidx=2
wpa_driver_madwifi_del_key: keyidx=3
wpa_driver_madwifi_del_key: keyidx=0
State: DISCONNECTED -> DISCONNECTED
wpa_driver_wext_set_operstate: operstate 0->0 (DORMANT)
WEXT: Operstate: linkmode=-1, operstate=5
EAPOL: External notification - portEnabled=0
EAPOL: External notification - portValid=0
RTM_NEWLINK: operstate=0 ifi_flags=0x1003 ([UP])
RTM_NEWLINK, IFLA_IFNAME: Interface 'ath0' added
State: DISCONNECTED -> SCANNING
Starting AP scan (broadcast SSID)
Trying to get current scan results first without requesting a new scan to speed up initial association
Received 777 bytes of scan results (3 BSSes)
Scan results: 3
AP count: 3
num_prio: 0
No APs found - clear blacklist and try again
Removed BSSID 00:00:00:00:00:00 from blacklist (clear)
No suitable AP found.
Setting scan request: 0 sec 0 usec
No enabled networks - do not scan
State: SCANNING -> INACTIVE
CTRL-EVENT-TERMINATING - signal 2 received
Removing interface ath0
State: INACTIVE -> DISCONNECTED
wpa_driver_wext_set_operstate: operstate 0->0 (DORMANT)
WEXT: Operstate: linkmode=-1, operstate=5
No keys have been configured - skip key clearing
EAPOL: External notification - portEnabled=0
EAPOL: External notification - portValid=0
wpa_driver_madwifi_set_drop_unencrypted: enabled=0
wpa_driver_madwifi_set_countermeasures: enabled=0
No keys have been configured - skip key clearing
Cancelling scan request
Cancelling authentication timeout
WEXT: Operstate: linkmode=0, operstate=6
==============

Thanks
PPN

--
My life has changed. What about yours?
Log on to the new Indiatimes Mail and Live out of the Inbox!