Senao NL-2511CD+ doesn't work with WPA-EAP

[Jouni Malinen]

On Mon, May 07, 2007 at 06:31:25PM +0200, Ruzsinszky Attila wrote:

> I can't see traffic on eth1 or wifi0 (eth1 = wlan0).

Is eth1 just renamed wlan0?

> Initializing interface 'wifi0' conf 'wpa_supplicant.conf' driver
> 'wext' ctrl_interface 'N/A'

wifi0 is incorrect interface to use here. You should use wlan0 (or
whatever it is renamed to).

> With interface eth1 the situation is the same!

Could you please send the debug log showing this?

> hostap: module not supported by Novell, setting U taint flag.
> hostap_cs: module not supported by Novell, setting U taint flag.
> hostap_cs: 0.4.4-kernel (Jouni Malinen <jkmaline at cc.hut.fi>)
> hostap_cs: setting Vcc=33 (constant)
> hostap_cs: setting Vcc=33 (from config)
> Checking CFTABLE_ENTRY 0x01 (default 0x01)
> IO window settings: cfg->io.nwin=1 dflt.io.nwin=1
> io->flags = 0x0046, io.base=0x0000, len=64
> hostap_cs: Registered netdevice wifi0
> hostap_cs: index 0x01: Vcc 3.3, irq 3, io 0x0100-0x013f

Is this all output from Host AP driver? I would have expected to see
more information here (e.g., firmware versions)..

-- 
Jouni Malinen                                            PGP id EFC895FA