Cisco Aironet AP?

[Mark Davis]

On 3/6/07, Bryan Kadzban <bryan at kadzban.is-a-geek.net> wrote:
>
> Bryan Kadzban wrote:
> > You probably need WPA or WPA2 here;
>
> Scratch that; it should be WPA-EAP.  (Serves me right for sending this
> before checking the config file documentation.  :-P)
>
> You may need to set proto to WPA or RSN (which is the same as WPA2), but
> I'm not sure whether that's needed.
>
>
>
Thanks for that, we're getting closer. Now it's deciding not to associate.
We don't broadcast the SSID on our APs. Would that be the cause of this?
The error below is getting the MAC of the AP but wpa_supplican't doesn't
believe that it's good.

Here's the debug trace:

Initializing interface (2) 'wlan0'
EAPOL: SUPP_PAE entering state DISCONNECTED
EAPOL: KEY_RX entering state NO_KEY_RECEIVE
EAPOL: SUPP_BE entering state INITIALIZE
EAP: EAP entering state DISABLED
EAPOL: External notification - portEnabled=0
EAPOL: External notification - portValid=0
SIOCGIWRANGE: WE(compiled)=19 WE(source)=13 enc_capa=0x0
  capabilities: key_mgmt 0x0 enc 0x3
Own MAC address: 00:05:4e:4f:8a:fb
wpa_driver_madwifi_del_key: keyidx=0
ioctl[IEEE80211_IOCTL_DELKEY]: Operation not supported
wpa_driver_madwifi_del_key: keyidx=1
ioctl[IEEE80211_IOCTL_DELKEY]: Operation not supported
wpa_driver_madwifi_del_key: keyidx=2
ioctl[IEEE80211_IOCTL_DELKEY]: Operation not supported
wpa_driver_madwifi_del_key: keyidx=3
ioctl[IEEE80211_IOCTL_DELKEY]: Operation not supported
wpa_driver_madwifi_set_countermeasures: enabled=0
wpa_driver_madwifi_set_drop_unencrypted: enabled=1
Setting scan request: 0 sec 100000 usec
Added interface wlan0
Wireless event: cmd=0x8b06 len=8
RTM_NEWLINK, IFLA_IFNAME: Interface 'wlan0' added
RTM_NEWLINK, IFLA_IFNAME: Interface 'wlan0' added
State: DISCONNECTED -> SCANNING
Starting AP scan (broadcast SSID)
Wireless event: cmd=0x8b1a len=8
Wireless event: cmd=0x8b19 len=8
Received 251 bytes of scan results (1 BSSes)
Scan results: 1
Selecting BSS from priority group 0
0: 00:14:a9:c8:0f:b0 ssid='' wpa_ie_len=26 rsn_ie_len=0 caps=0x11
   skip - SSID mismatch
No suitable AP found.
Setting scan request: 5 sec 0 usec
Starting AP scan (broadcast SSID)
Wireless event: cmd=0x8b1a len=8
Wireless event: cmd=0x8b19 len=8
Received 251 bytes of scan results (1 BSSes)
Scan results: 1
Selecting BSS from priority group 0
0: 00:14:a9:c8:0f:b0 ssid='' wpa_ie_len=26 rsn_ie_len=0 caps=0x11
   skip - SSID mismatch
No suitable AP found.
Setting scan request: 5 sec 0 usec
CTRL-EVENT-TERMINATING - signal 2 received
Removing interface wlan0
State: SCANNING -> DISCONNECTED
No keys have been configured - skip key clearing
EAPOL: External notification - portEnabled=0
EAPOL: External notification - portValid=0
wpa_driver_madwifi_set_drop_unencrypted: enabled=0
wpa_driver_madwifi_set_countermeasures: enabled=0
No keys have been configured - skip key clearing
Cancelling scan request
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.shmoo.com/pipermail/hostap/attachments/20070306/8e27ae10/attachment.htm