unknow algorithm 'CCMP'; or problem flashing (secondary?') firmware

[Michael Gross]

Hello,

when I try to connect to a wpa-network with Radius-auth I get the
following message in wpa_supplicant debug mode:

Failed to set encryption.
Unknown algorithm 'CCMP'.
You may need to load kernel module to register that algorithm.
E.g., 'modprobe hostap_crypt_wep' for WEP.
WPA: Failed to set PTK to the driver.


Googleing didn't bring any meaningful results exept for one stating
that I should type 'modprobe hostap_crypt_tkip' which wasn't of much
help since there are no hostap_crypt_* modules present on my system.

kernel: 2.6.18-gentoo-r6  with hostap as modules
card: SanDisk ConnectPlus 128   (prism chipset), Firmware 1.8.4

------------------------------------------------------------------------------------------------

could also be a problem with the firmware flashing. When I try to do
that with the follwing commands:

prism2_srec -gs wlan0 $TOP/pm010102.hex
prism2_srec -gp wlan0 $TOP/pm010102.hex #fail
iwpriv wlan0 reset 1
prism2_srec -rp wlan0 $TOP/rf010804.hex



I get this output:

srec summary for pm010102.hex
Included file name: PM010102.HEX
Component: 0x0015 1.1.2 (primary firmware)


Verifying update compatibility and combining data:
Plugging PDR 0400 (NIC configuration): ram16=1 pci=0 (03 00)
OK.

Downloading to volatile memory (RAM).
OK.
srec summary for pm010102.hex
Included file name: PM010102.HEX
Component: 0x0015 1.1.2 (primary firmware)

ioctl[PRISM2_IOCTL_HOSTAPD]: No data available
STAID not available (maybe running PRI-only)
ioctl[PRISM2_IOCTL_HOSTAPD]: No data available
ioctl[PRISM2_IOCTL_HOSTAPD]: No data available

Verifying update compatibility and combining data:
Plug record length mismatch (PDR=0x0001): 6 != 16
==> extend from default
OK.

Downloading to volatile memory (RAM).
OK.
srec summary for rf010804.hex
Included file name: rf010804.hex
Component: 0x001f 1.8.4 (station firmware)

ioctl[PRISM2_IOCTL_HOSTAPD]: No data available
STAID not available (maybe running PRI-only)
ioctl[PRISM2_IOCTL_HOSTAPD]: No data available
ioctl[PRISM2_IOCTL_HOSTAPD]: No data available

Verifying update compatibility and combining data:
OK.

Downloading to volatile memory (RAM).
OK.
Components after download:
  NICID: 0x801d v1.0.0
  PRIID: 0x0015 v1.1.2
  STAID: 0x001f v1.8.4



I got the firmware from this site: www.red-bean.com/~proski/firmware/

Thank you for your help.
Have a nice weekend.

Michael