Configuring wpa_supplicant for wired network

[Dan Williams]

On Sun, 2006-11-05 at 22:21 -0800, Mahantesh P wrote:
> Hi All,
> 
> I need help on configuring wpa_supplicant.
> 
> I want to use WPA supplicant on wired LAN (Ethernet card) and use PEAP
> authentication. My PC is connected to a switch with 802.1x
> capabilities there is wireless access point. 

You'll also need to be sure you use ap_scan=0 near the top.

Dan

> network={
> 
> ssid="university"---------------------------------------------------------?
> 
> scan_ssid=0-------------------------------------------------------?
>     proto=WPA-------------------------------------what should i set
> this to     "EAPOL"?? 
>     key_mgmt=IEEE8021X
>     eap=TTLS---------------------------------------------PEAP
>     pairwise=TKIP-------------------------------------- ?
>     group=TKIP------------------------------------------?
>     identity="username" 
>     password="password"
>     ca_cert=/home/david/wireless/UOP-b64.cer"
>     phase="auth=PAP"
> }
> 
> Thank you very much, Please respond and give your suggestions.
> 
> 
> Regards,
> Mahantesh.P
> 
> 
> 
> _______________________________________________
> HostAP mailing list
> HostAP at shmoo.com
> http://lists.shmoo.com/mailman/listinfo/hostap