CVS: WPA/WPA2 WPA-PSK/TLS TKIP/CCMP: EAPOL-Key timeout s in 1/4 msg of 4-Way Handshake: win+linux clients, madwifi with WG311T, DWL-G650

[thomas schorpp]

Jouni Malinen wrote:
> On Thu, May 19, 2005 at 04:09:33AM +0200, thomas schorpp wrote:
> 
> 
>>softwares: hostapd 0.3.6...CVS, client: dlink supplicant on win98 or
>>wpasupplicant 0.3.8-1 debian on linux, madwifi cvs on both.
> 
> 
> Which version of madwifi cvs are you using? The CVS trunk does not seem
> to work with hostapd, but I was able to use the snapshot version from
> 'BSD' branch with hostapd couple of weeks ago.
> 

thx for fast reply. so madwifi? sounds bad.

hmm.. what you get with proposed standard checkout... i assume head, no
special branch:

May 19 02:33:48 tom3 kernel: ath_pci: driver unloaded
May 19 02:33:48 tom3 kernel: ath_rate_onoe: unloaded
May 19 02:33:48 tom3 kernel: ath_hal: driver unloaded
May 19 02:34:09 tom3 kernel: ath_hal: 0.9.14.9 (AR5210, AR5211, AR5212,
RF5111, RF5112, RF2413)
May 19 02:34:09 tom3 kernel: ath_rate_onoe: 1.0
May 19 02:34:09 tom3 kernel: ath_pci: 0.9.4.12 (EXPERIMENTAL)
May 19 02:34:09 tom3 kernel: PCI: Found IRQ 10 for device 0000:00:10.0
May 19 02:34:09 tom3 kernel: PCI: Sharing IRQ 10 with 0000:00:07.2
May 19 02:34:09 tom3 kernel: PCI: Sharing IRQ 10 with 0000:00:0f.1
May 19 02:34:09 tom3 kernel: ath0: 11b rates: 1Mbps 2Mbps 5.5Mbps 11Mbps
May 19 02:34:09 tom3 kernel: ath0: 11g rates: 1Mbps 2Mbps 5.5Mbps 11Mbps
6Mbps 9Mbps 12Mbps 18Mbps 24Mbps 36Mbps 48Mbps 54Mbps
May 19 02:34:09 tom3 kernel: ath0: mac 5.9 phy 4.3 radio 4.6
May 19 02:34:09 tom3 kernel: ath0: 802.11 address: 00:0f:b5:63:e0:f2
May 19 02:34:09 tom3 kernel: ath0: Use hw queue 0 for WME_AC_BE traffic
May 19 02:34:09 tom3 kernel: ath0: Use hw queue 1 for WME_AC_BK traffic
May 19 02:34:09 tom3 kernel: ath0: Use hw queue 2 for WME_AC_VI traffic
May 19 02:34:09 tom3 kernel: ath0: Use hw queue 3 for WME_AC_VO traffic
May 19 02:34:09 tom3 kernel: ath0: Atheros 5212: mem=0xfebc0000, irq=10
tom3:~#

driver reports 5212 chip, but its 5213... hope its compatible, card is
rev. 01 according to pcb printing.

remarkable too, i never see the act led blinking or just too fast...

y
tom