USRobotics PCMCIA Card

[Gargi D]

I am looking for PCMCIA cards with to work with HostAP.  It is getting
slightly difficult to get cards with PRISM Support.  Please let me know if
the following cards specs will work

USRobotics WLAN Card - Model USR12410
Version - USR03-1.33

The hostap.conf file specifies the requirement as
card "U.S. Robotics IEEE 802.11b PC-CARD"
   version "U.S. Robotics", "IEEE 802.11b PC-CARD", "Version 01.02"
#   manfid 0x0156, 0x0002
   bind "hostap_cs"

There is some discrepancy in the version numbers of what is available and
what is specified.  The version specified in hostap.conf is 1.02 whereas
that available is 1.33.  Is this the firmware version?  Will card with the
above spec work?

Thanks,

Gargi.

----- Original Message -----
From: "AP-Research" <HostAP-Research at maxrack.net>
To: <hostap at shmoo.com>
Sent: Wednesday, June 09, 2004 9:08 AM
Subject: Wireless Link Monitor 2.6.0


> Wireless Link Monitor 2.6.0 shows correct data for orinoco driver.
> ...shows N/A if I load card which requires hostap_cs et. al.
> ...remove hostap_cs et. al. and it responds again for orinoco...
>
> --
> Regards
> KC Ferguson
> _______________________________________________
> HostAP mailing list
> HostAP at shmoo.com
> http://lists.shmoo.com/mailman/listinfo/hostap