DWL 520 rev. E

[jthorp at redfish.com]

Hi All,

I've been trying to get my new DWL 520 E card working (after a couple of
days believing it was a <B> revision card).

I've downloaded the latest CVS:
I can load the module:
modprobe hostap_pci no_primary =1

I've dowloaded  PM010102.HEX but I am getting:
"""
bash-2.05b# /root/hostap/utils/prism2_srec -v  wifi0 pm010102.hex
Special S3 firmware info record - name 'PM010102.HEX'
Start address 0x003f0000
S3 CRC-16 generation record: start=0x007E17FE len=2 prog=0
srec summary for pm010102.hex
Included file name: PM010102.HEX
Component: 0x0015 1.1.2 (primary firmware)
Supported platforms:
  0x800e 1.0.0,  0x8015 1.0.0,  0x8019 1.0.0,  0x801d 1.0.0,  0x8024 1.0.0
Interface compatibility information:
  role=Supplier variant=2 range=4-4 iface=Primary Firmware-Driver (3)
  role=Actor    variant=2 range=1-1 iface=Controller-Firmware (2)
Separate S3 data areas:
S3 area count: 3
  addr=0x007E0000..0x007E092F (len=2352)
  addr=0x007E0A00..0x007E13D7 (len=2520)
  addr=0x007E17FE..0x007E17FF (len=2)
Total data length: 4874
Start address 0x003f0000

ioctl[PRISM2_IOCTL_HOSTAPD]: Inappropriate ioctl for device
Missing wlan component info
Could not read wlan RIDs
"""

dmesg shows:

hostap_pci: CVS (Jouni Malinen <jkmaline at cc.hut.fi>)
hostap_pci: Registered netdevice wifi0
wifi0: Original COR value: 0x0
hostap_pci: assuming no Primary image in flash - card initialization not
completed
wifi0: test Genesis mode with HCR 0x1f
wifi0: Original COR value: 0x0
Readback test failed, HCR 0x1f write 00 e1 a1 ff read 00 ce a1 ce
wifi0: test Genesis mode with HCR 0x0f
wifi0: Original COR value: 0xa1
Readback test succeeded, HCR 0x0f
wifi0: Intersil Prism2.5 PCI: mem=0xfebfe000, irq=9
wifi0: registered netdevice wlan0
wifi0: cannot get RID fd0b (len=1008) - no PRI f/w


Any ideas what is happening?

thanks,
Joshua