TX Rate Control
Fri May 9 03:02:07 PDT 2003
Eventhough with lastest CVS Tree "Tx Rate Control" does not work correctly..
When I change the Tx rate using "iwconfig wlan0 rate 1M or 2M or 5.5M or 11M or auto" or
iwpriv wlan0 prism2_param oper_rates (bit filed value , 1, 2, 4, 8 or 15)
Client 's current tx power does not changed. It always display 11Mbps ...
Of course, I have tested with other AP. When I changed It's supported rate.. then the Client show correct information..
As a result, the Client Card believable..
Could you Please, check it again ?
More information about the Hostap