Netgear PCI MA311 Problems

[Brian Sugar]

Hi. I just installed Netgear PCI MA311 and works perfectly as a client 
to my AirPort (albeit no wep yet but use mac addresses for now).  Now I 
am trying to setup as an Access Point.  Following problems happen after 
I compile hostap:

# /sbin/modprobe hostap_pci
/lib/modules/2.4.20-8/net/hostap_pci.o: init_module: No such device
Hint: insmod errors can be caused by incorrect module parameters, 
including invalid IO or IRQ parameters.
       You may find more information in syslog or the output from dmesg
/lib/modules/2.4.20-8/net/hostap_pci.o: insmod 
/lib/modules/2.4.20-8/net/hostap_pci.o failed
/lib/modules/2.4.20-8/net/hostap_pci.o: insmod hostap_pci failed


# dmesg
hostap_pci: 0.0.2 - 2003-05-03 (Jouni Malinen <jkmaline at cc.hut.fi>)
hostap_pci: No devices found, driver not installed.
hostap_crypt: unregistered algorithm 'NULL' (deinit)


# /sbin/lspci | grep Prism
00:0e.0 Network controller: Harris Semiconductor Prism 2.5 Wavelan 
chipset (rev 01)


# /sbin/ifconfig wlan0
wlan0     Link encap:Ethernet  HWaddr 00:09:5B:41:38:6E
           inet addr:192.168.1.192  Bcast:192.168.1.255  
Mask:255.255.255.0
           UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
           RX packets:2013 errors:0 dropped:0 overruns:0 frame:0
           TX packets:852 errors:0 dropped:0 overruns:0 carrier:0
           collisions:0 txqueuelen:100
           RX bytes:167149 (163.2 Kb)  TX bytes:104707 (102.2 Kb)
           Interrupt:10 Memory:ce902000-ce903000


Please help.


--
Brian