arm hostap problems...

[Vincas Ciziunas]

also, if  I use the monitor mode and I insert the card after the pcmcia
servicees have started, this is the dmesg output:

Enabling monitor mode
Enabling monitor mode
wlan0: CMD=0x0121 => res=0x7f, resp0=0x0004
wlan0: hfa384x_set_rid: CMDCODE_ACCESS_WRITE failed (res=127, rid=fc28,
len=2)
WEP flags setting failed

any ideas on what could be going wrong??



On Tue, 1 Jul 2003, Vincas Ciziunas wrote:

> I saw the following message in the archives and was wondering if anything
> has come of it...I'd appreciate hearing any input anyone might have on
> this problem.  It only seems to do this on an ipaq, it does not seem to
> do this on a sharp zaurus:
>
> channel / mode changing on arm
> Florian Boor boor at somewhere
> Thu Jun 12 14:21:22 GMT 2003
>
>
> --------------------------------------------------------------------------------
>
> Hello!
>
> Jouni Malinen wrote:
>
> > Please include 'dmesg' output after such a failure when reporting
> > problems.
>
> This happens when you switch to monitor mode and start to change channels.
> The card that was uses is a Netgear MA401RA.
>
> Here it is the output from dmesg:
>
> Enabling monitor mode
> wlan0: CMD=0x0121 => res=0x7f, resp0=0x0004
> wlan0: hfa384x_set_rid: CMDCODE_ACCESS_WRITE failed (res=127, rid=fc28,
> len=2)
> WEP flags setting failed
> device wlan0 entered promiscuous mode
> wlan0: hfa384x_setup_bap - timeout after
> wlan0: hfa384x_set_rid (rid=fc03, len=2) - failed - res=-110
> wlan0: hfa384x_setup_bap - timeout before
> wlan0: hfa384x_set_rid (rid=fc03, len=2) - failed - res=-110
> wlan0: hfa384x_setup_bap - timeout before
> wlan0: hfa384x_set_rid (rid=fc03, len=2) - failed - res=-110
> wlan0: hfa384x_setup_bap - timeout before
> ... repeats while changing channel ...
>
> ----------------------------------------------------------------
>
> _______________________________________________
> HostAP mailing list
> HostAP at shmoo.com
> http://lists.shmoo.com/mailman/listinfo/hostap
>