arm hostap problems...

[Vincas Ciziunas]

I saw the following message in the archives and was wondering if anything
has come of it...I'd appreciate hearing any input anyone might have on
this problem.  It only seems to do this on an ipaq, it does not seem to
do this on a sharp zaurus:

channel / mode changing on arm
Florian Boor boor at somewhere
Thu Jun 12 14:21:22 GMT 2003


--------------------------------------------------------------------------------

Hello!

Jouni Malinen wrote:

> Please include 'dmesg' output after such a failure when reporting
> problems.

This happens when you switch to monitor mode and start to change channels.
The card that was uses is a Netgear MA401RA.

Here it is the output from dmesg:

Enabling monitor mode
wlan0: CMD=0x0121 => res=0x7f, resp0=0x0004
wlan0: hfa384x_set_rid: CMDCODE_ACCESS_WRITE failed (res=127, rid=fc28,
len=2)
WEP flags setting failed
device wlan0 entered promiscuous mode
wlan0: hfa384x_setup_bap - timeout after
wlan0: hfa384x_set_rid (rid=fc03, len=2) - failed - res=-110
wlan0: hfa384x_setup_bap - timeout before
wlan0: hfa384x_set_rid (rid=fc03, len=2) - failed - res=-110
wlan0: hfa384x_setup_bap - timeout before
wlan0: hfa384x_set_rid (rid=fc03, len=2) - failed - res=-110
wlan0: hfa384x_setup_bap - timeout before
... repeats while changing channel ...

----------------------------------------------------------------