WDS cannot connect
Stuart Frame
stuart
Sun Dec 21 19:06:20 PST 2003
Sorry for the long post, but I am at a dead end and was after any type of
help possible.
I am trying to use WDS to connect to a remote cisco AP, it?s about 1KM
away and I am able to connected to it fine with hostap in managed mode ?
but not in master. The plan is to create another AP with hostap connected
back to the cisco AP (1200) with WDS.
I have attached some configs, the local side of the hostap is working and
i can ping it from a client. I cannot ping through to the the Cisco or
even from the hostAP box through to the cisco AP.
Any ideas?
Stuart Frame
--------------------------dmesg, boot
Linux version 2.4.22 (root at midas) (gcc version 3.2.3) #23 Tue Sep 2
18:16:57 PDT 2003
Intel PCIC probe:
Intel i82365sl B step ISA-to-PCMCIA at port 0x3e0 ofs 0x00, 2 sockets
hostap_crypt: registered algorithm 'NULL'
hostap_cs: 0.1.0 - 2003-10-14 (Jouni Malinen <jkmaline at cc.hut.fi>)
hostap_cs: setting Vcc=33 (constant)
hostap_cs: CS_EVENT_CARD_INSERTION
hostap_cs: ignoring Vcc=50 (from config)
Checking CFTABLE_ENTRY 0x01 (default 0x01)
IO window settings: cfg->io.nwin=1 dflt.io.nwin=1
io->flags = 0x0046, io.base=0x0000, len=64
hostap_cs: index 0x01: Vcc 5.0, irq 5, io 0x0100-0x013f
hostap_cs: Registered netdevice wlan0
prism2_hw_init: initialized in 240 ms
wlan0: NIC: id=0x800c v1.0.0
wlan0: PRI: id=0x15 v1.1.1
wlan0: STA: id=0x1f v1.5.6
wlan0: adding automatic WDS connection to AP 00:0c:30:94:23:5a
wlan0: registered netdevice wlan0wds0
NET4: Ethernet Bridge 008 for NET4.0
device wlan0 entered promiscuous mode
device wlan0wds0 entered promiscuous mode
wlan0wds0: attempt to add interface with same source address.
br0: port 2(wlan0wds0) entering learning state
br0: port 1(wlan0) entering learning state
br0: port 2(wlan0wds0) entering forwarding state
br0: topology change detected, propagating
br0: port 1(wlan0) entering forwarding state
br0: topology change detected, propagating
--------------- ifconfig
br0 Link encap:Ethernet HWaddr 00:02:6F:04:0F:A2
inet addr:192.168.1.10 Bcast:192.168.1.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:24 errors:0 dropped:0 overruns:0 frame:0
TX packets:24 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:2358 (2.3 Kb) TX bytes:2358 (2.3 Kb)
wlan0 Link encap:Ethernet HWaddr 00:02:6F:04:0F:A2
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:158 overruns:0 frame:0
TX packets:51 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:0 (0.0 b) TX bytes:3672 (3.5 Kb)
Interrupt:3 Base address:0x100
wlan0wds0 Link encap:Ethernet HWaddr 00:02:6F:04:0F:A2
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Interrupt:3 Base address:0x100
-----------------iwconfig
wlan0 IEEE 802.11b ESSID:"hut"
Mode:Master Frequency:2.437GHz Access Point:
00:02:6F:04:0F:A2
Bit Rate:11Mb/s Sensitivity=1/3
Retry min limit:8 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
wlan0wds IEEE 802.11b ESSID:"hut"
Mode:Master Frequency:2.437GHz Access Point:
00:02:6F:04:0F:A2
Bit Rate:11Mb/s Sensitivity=1/3
Retry min limit:8 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
-------------route
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use
Iface
localnet * 255.255.255.0 U 0 0 0
br0
loopback * 255.0.0.0 U 0 0 0 lo
------------traceroute 192.168.1.200
1 toshi.stu.com (192.168.1.10) 3001.315 ms !H 2999.278 ms !H 2999.378
ms !H
---------ping 192.168.1.200
PING 192.168.1.200 (192.168.1.200) 56(84) bytes of data.
>From 192.168.1.10 icmp_seq=1 Destination Host Unreachable
-------- cat /proc/net/hostap/wlan0/00:0c:30:94:23:5a
AP=00:0c:30:94:23:5a
users=0
aid=0
flags=0x0003 AUTH ASSOC
capability=0x21
listen_interval=100
supported_rates=1Mbps 2Mbps 5.5Mbps 11Mbps
jiffies=411561
last_auth=0
last_assoc=0
last_rx=411558
last_tx=411560
rx_packets=36981
tx_packets=2103
rx_bytes=1184013
tx_bytes=298697
buffer_count=0
last_rx: silence=156 signal=172 rate=10
tx_rate=110
tx[1M]=0
tx[2M]=0
tx[5.5M]=0
tx[11M]=2103
rx[1M]=36981
rx[2M]=0
rx[5.5M]=0
rx[11M]=0
channel=6
ssid=hut
Stuart Frame,
IT Manager, Niue Island.
More information about the Hostap
mailing list