hostapd simple configuration

Jouni Malinen jkmaline
Wed Aug 13 17:49:55 PDT 2003


On Wed, Aug 13, 2003 at 04:28:09PM -0300, Leonardo Pereira Santos wrote:

> #hostapd -d /etc/hostapd.conf

Which version of hostapd (and driver) are you using?

> authentication reply: STA=00:02:78:e1:b0:49 auth_alg=0 auth_transaction=2 
> resp=0
> MGMT (TX callback) fail
> mgmt::auth cb
> wlan0: STA 00:02:78:e1:b0:49 IEEE 802.11: did not acknowledge authentication 
> response

For some reason, the client did not send IEEE 802.11 ACK frame for the
authentication frame that the AP sent. Usually this happens when too
much time is used between the authentication frames. Wi-Fi certification
requires that stations wait at least 100 ms for this, but I do not know
what timeout values are really used. Are you sending that debug output
through serial console? Did you test the same thing with debugging
disabled? Which Prism2 card are you using? How fast is the host system?

> While at the station, I get:
> 
> #xsupplicant -i wlan0
> Setup on device wlan0 complete
> set globals.
> Done with init.
> Sending EAPOL-Start #1
> Sending EAPOL-Start #2
> No authenticator found! Assuming the port is authorized!

Not much use in testing xsupplicant yet since even the IEEE 802.11
authentication failed.

-- 
Jouni Malinen                                            PGP id EFC895FA




More information about the Hostap mailing list