[PATCH 10/15] ARM: remove non PBL Atmel boards

[Sam Ravnborg]

On Fri, Apr 26, 2024 at 12:59:10PM +0200, Sascha Hauer wrote:
> Hi Sam,
> 
> On Thu, Apr 25, 2024 at 06:56:48PM +0200, Sam Ravnborg wrote:
> > Hi Sascha
> > 
> > On Thu, Apr 25, 2024 at 01:54:34PM +0200, Sascha Hauer wrote:
> > > Some Atmel AT91 boards still do not have PBL support which becomes
> > > mandatory soon. Remove these boards.
> > > 
> > > Signed-off-by: Sascha Hauer <s.hauer at pengutronix.de>
> > > ---
> > >  arch/arm/boards/Makefile                      |   3 -
> > >  arch/arm/boards/sama5d3xek/Makefile           |   6 -
> > >  .../defaultenv-sama5d3xek/bin/init_board      |  15 -
> > >  .../sama5d3xek/defaultenv-sama5d3xek/config   |  44 --
> > >  arch/arm/boards/sama5d3xek/hw_version.c       | 236 ---------
> > >  arch/arm/boards/sama5d3xek/hw_version.h       |  40 --
> > >  arch/arm/boards/sama5d3xek/init.c             | 475 ------------------
> > >  arch/arm/boards/sama5d3xek/lowlevel.c         |  23 -
> > >  arch/arm/boards/sama5d4_xplained/Makefile     |   4 -
> > I have patches that DT enable this board, and an attempt to
> > add PBL support (which did not succeed).
> > 
> > I did not touch the patches since last summer, so some rebasing is
> > required.
> > I will try to find time to give it a spin within the next days and
> > post the result.
> 
> Ok, thanks. I'll mark the board as broken then instead of removing it.
Good plan then you do not need to wait for me.
The rest of the patches looked like nice cleanup all over.

	Sam