[PATCH 10/15] ARM: remove non PBL Atmel boards

[Sascha Hauer]

Hi Sam,

On Thu, Apr 25, 2024 at 06:56:48PM +0200, Sam Ravnborg wrote:
> Hi Sascha
> 
> On Thu, Apr 25, 2024 at 01:54:34PM +0200, Sascha Hauer wrote:
> > Some Atmel AT91 boards still do not have PBL support which becomes
> > mandatory soon. Remove these boards.
> > 
> > Signed-off-by: Sascha Hauer <s.hauer at pengutronix.de>
> > ---
> >  arch/arm/boards/Makefile                      |   3 -
> >  arch/arm/boards/sama5d3xek/Makefile           |   6 -
> >  .../defaultenv-sama5d3xek/bin/init_board      |  15 -
> >  .../sama5d3xek/defaultenv-sama5d3xek/config   |  44 --
> >  arch/arm/boards/sama5d3xek/hw_version.c       | 236 ---------
> >  arch/arm/boards/sama5d3xek/hw_version.h       |  40 --
> >  arch/arm/boards/sama5d3xek/init.c             | 475 ------------------
> >  arch/arm/boards/sama5d3xek/lowlevel.c         |  23 -
> >  arch/arm/boards/sama5d4_xplained/Makefile     |   4 -
> I have patches that DT enable this board, and an attempt to
> add PBL support (which did not succeed).
> 
> I did not touch the patches since last summer, so some rebasing is
> required.
> I will try to find time to give it a spin within the next days and
> post the result.

Ok, thanks. I'll mark the board as broken then instead of removing it.

Sascha

-- 
Pengutronix e.K.                           |                             |
Steuerwalder Str. 21                       | http://www.pengutronix.de/  |
31137 Hildesheim, Germany                  | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |