[PATCH v2 32/34] ARM: mmu32: Use pages for early MMU setup

[Ahmad Fatoum]

On 17.05.23 11:03, Sascha Hauer wrote:
> Up to now we use 1MiB sections to setup the page tables in PBL. There
> are two places where this leads to problems. First is OP-TEE, we have
> to map the OP-TEE area with PTE_EXT_XN to prevent the instruction
> prefetcher from speculating into that area. With the current section
> mapping we have to align OPTEE_SIZE to 1MiB boundaries. The second
> problem comes with SRAM where the PBL might be running. This SRAM has
> to be mapped executable, but at the same time we should map the
> surrounding areas non executable which is not always possible with
> 1MiB mapping granularity.
> 
> We now have everything in place to use two level page tables from PBL,
> so use arch_remap_range() for the problematic cases.
> 
> Signed-off-by: Sascha Hauer <s.hauer at pengutronix.de>
> ---
>  arch/arm/cpu/mmu_32.c | 31 +++++++------------------------
>  1 file changed, 7 insertions(+), 24 deletions(-)
> 
> diff --git a/arch/arm/cpu/mmu_32.c b/arch/arm/cpu/mmu_32.c
> index 785b20c7fd..705d27a045 100644
> --- a/arch/arm/cpu/mmu_32.c
> +++ b/arch/arm/cpu/mmu_32.c
> @@ -111,8 +111,10 @@ void dma_flush_range(void *ptr, size_t size)
>  	unsigned long end = start + size;
>  
>  	__dma_flush_range(start, end);
> +#ifndef __PBL__
>  	if (outer_cache.flush_range)
>  		outer_cache.flush_range(start, end);
> +#endif

Meh. I see why this is ok (L2X0 currently initialized in initcall), but this
#ifdef looks a bit too fragile. Perhaps, we could do this in <asm/mmu.h> instead?

#ifdef __PBL__
/* Existing platforms with non-architected outer cache initialize it
 * outside PBL and new ones will likely only have architected caches,
 * so we provide a dummy here
 */
static __maybe_unused struct outer_cache_fns outer_cache;
#else
extern struct outer_cache_fns outer_cache;
#endif

>  }
>  
>  void dma_inv_range(void *ptr, size_t size)
> @@ -120,8 +122,10 @@ void dma_inv_range(void *ptr, size_t size)
>  	unsigned long start = (unsigned long)ptr;
>  	unsigned long end = start + size;
>  
> +#ifndef __PBL__
>  	if (outer_cache.inv_range)
>  		outer_cache.inv_range(start, end);
> +#endif
>  	__dma_inv_range(start, end);
>  }
>  
> @@ -542,16 +546,6 @@ void *dma_alloc_writecombine(size_t size, dma_addr_t *dma_handle)
>  	return dma_alloc_map(size, dma_handle, ARCH_MAP_WRITECOMBINE);
>  }
>  
> -static inline void map_region(unsigned long start, unsigned long size,
> -			      uint64_t flags)
> -
> -{
> -	start = ALIGN_DOWN(start, SZ_1M);
> -	size  = ALIGN(size, SZ_1M);
> -
> -	create_sections(start, start + size - 1, flags);
> -}
> -
>  void mmu_early_enable(unsigned long membase, unsigned long memsize)
>  {
>  	uint32_t *ttb = (uint32_t *)arm_mem_ttb(membase + memsize);
> @@ -572,21 +566,10 @@ void mmu_early_enable(unsigned long membase, unsigned long memsize)
>  	 */
>  	create_flat_mapping();
>  
> -	/*
> -	 * There can be SoCs that have a section shared between device memory
> -	 * and the on-chip RAM hosting the PBL. Thus mark this section
> -	 * uncachable, but executable.
> -	 * On such SoCs, executing from OCRAM could cause the instruction
> -	 * prefetcher to speculatively access that device memory, triggering
> -	 * potential errant behavior.
> -	 *
> -	 * If your SoC has such a memory layout, you should rewrite the code
> -	 * here to map the OCRAM page-wise.
> -	 */
> -	map_region((unsigned long)_stext, _etext - _stext, PMD_SECT_DEF_UNCACHED);
> -
>  	/* maps main memory as cachable */
> -	map_region(membase, memsize - OPTEE_SIZE, PMD_SECT_DEF_CACHED);
> +	arch_remap_range((void *)membase, memsize - OPTEE_SIZE, MAP_CACHED);
> +	arch_remap_range((void *)membase + memsize - OPTEE_SIZE, OPTEE_SIZE, MAP_UNCACHED);
> +	arch_remap_range(_stext, PAGE_ALIGN(_etext - _stext), MAP_CACHED);

Rest looks fine. With above point addressed:

Reviewed-by: Ahmad Fatoum <a.fatoum at pengutronix.de>

>  
>  	__mmu_cache_on();
>  }

-- 
Pengutronix e.K.                           |                             |
Steuerwalder Str. 21                       | http://www.pengutronix.de/  |
31137 Hildesheim, Germany                  | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |