[PATCH] ddr: imx8m: add comment and print out prior to first DDRC read

[Sascha Hauer]

On Thu, Jul 06, 2023 at 06:16:40PM +0200, Ahmad Fatoum wrote:
> If board code low level entry forgets to call imx8m*_early_clock_init
> before DRAM setup, write access to DRAM controller will seem to work,
> but the first read access will hang the system.
> 
> Make debugging this board bring up mistake easier by adding a debug
> print along with a comment.
> 
> Signed-off-by: Ahmad Fatoum <a.fatoum at pengutronix.de>
> ---
>  drivers/ddr/imx8m/ddr_init.c | 6 +++++-
>  1 file changed, 5 insertions(+), 1 deletion(-)

Applied, thanks

Sascha

> 
> diff --git a/drivers/ddr/imx8m/ddr_init.c b/drivers/ddr/imx8m/ddr_init.c
> index 944cc3873e0c..9a86280d9c73 100644
> --- a/drivers/ddr/imx8m/ddr_init.c
> +++ b/drivers/ddr/imx8m/ddr_init.c
> @@ -106,7 +106,11 @@ int imx8m_ddr_init(struct dram_timing_info *dram_timing,
>  	reg32_write(DDRC_RFSHCTL3(0), 0x0000001);
>  	reg32_write(DDRC_PWRCTL(0), 0xa0);
>  
> -	/* if ddr type is LPDDR4, do it */
> +	pr_debug("checking ddr type\n");
> +	/*
> +	 * below is first read, so if boot hangs here, imx8m*_early_clock_init()
> +	 * might not have been called
> +	 */
>  	tmp = reg32_read(DDRC_MSTR(0));
>  	if (tmp & (0x1 << 5) && ddrc_type != DDRC_TYPE_MN)
>  		reg32_write(DDRC_DDR_SS_GPR0, 0x01); /* LPDDR4 mode */
> -- 
> 2.39.2
> 
> 
> 

-- 
Pengutronix e.K.                           |                             |
Steuerwalder Str. 21                       | http://www.pengutronix.de/  |
31137 Hildesheim, Germany                  | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |