[PATCH v2 0/4] Add support for the Kosagi Novena board

[John Watts]

This patch series introduces support for the Novena board.
This support is basic but enough to boot Barebox.

The EEPROM code here is included in anticipation for reading the features
flag in the future when more board features are supported.

Changes v1 -> v2:
- The board uses the driver model now
- Memory density is now calculated correctly

John Watts (4):
  ARM: novena: Add Kosagi Novena board
  ARM: novena: Setup RAM using static configuration
  ARM: novena: Read Ethernet MAC address from EEPROM
  ARM: novena: Use DDR3 information from SPD EEPROM

 arch/arm/boards/Makefile                      |   1 +
 arch/arm/boards/novena/Makefile               |   4 +
 arch/arm/boards/novena/board.c                | 114 ++++++++++
 arch/arm/boards/novena/ddr_regs.h             | 119 +++++++++++
 .../boards/novena/flash-header-novena.imxcfg  |   6 +
 arch/arm/boards/novena/lowlevel.c             | 198 ++++++++++++++++++
 arch/arm/configs/imx_v7_defconfig             |   1 +
 arch/arm/dts/Makefile                         |   1 +
 arch/arm/dts/imx6q-novena.dts                 |  19 ++
 arch/arm/mach-imx/Kconfig                     |   8 +
 images/Makefile.imx                           |   2 +
 11 files changed, 473 insertions(+)
 create mode 100644 arch/arm/boards/novena/Makefile
 create mode 100644 arch/arm/boards/novena/board.c
 create mode 100644 arch/arm/boards/novena/ddr_regs.h
 create mode 100644 arch/arm/boards/novena/flash-header-novena.imxcfg
 create mode 100644 arch/arm/boards/novena/lowlevel.c
 create mode 100644 arch/arm/dts/imx6q-novena.dts

-- 
2.39.0