[PATCH 0/3] fixes and sanity checks for mxs pinmuxing

Uwe Kleine-König u.kleine-koenig at pengutronix.de
Thu Oct 23 15:45:58 PDT 2014


Hello,

this series helped me to find pinmuxing problems on an i.MX28 machine.

The pins either have a pull up, a bit keeper or neither. For example the pin
ENET0_RXD2 has a bit keeper, and so doing

	imx_gpio_mode(ENET0_RXD2 | VE_3_3V | STRENGTH(S8MA) | PULLUP(1))

obviously couldn't enable the pull up as requested. Instead it enabled the bit
keeper. With this series the above call results in a message that the mode is
invalid and the pullup and bitkeeper register settings are not touched.

Note that I didn't test on i.MX23 even though this SoC is affected, too. I
currently don't have an i.MX23 handy, so I couldn't test this part.

Uwe Kleine-König (3):
  mxs: iomux-imx28: Fix keeper/pullup/drive strength/voltage flags
  mxs: iomux-imx23/imx28: unify mode definition
  mxs: iomux-imx23/imx28: add additional checks on mode

 arch/arm/mach-mxs/include/mach/iomux-imx23.h |  61 ---------------
 arch/arm/mach-mxs/include/mach/iomux-imx28.h | 112 +++++++--------------------
 arch/arm/mach-mxs/include/mach/iomux.h       |  82 ++++++++++++++++++++
 arch/arm/mach-mxs/iomux-imx.c                |  23 +++++-
 4 files changed, 127 insertions(+), 151 deletions(-)

-- 
2.1.1




More information about the barebox mailing list