Changing the baudrate via barebox prompt

[Antony Pavlov]

On Wed, 14 May 2014 12:59:53 +0800
Kevin Du Huanpeng <u74147 at gmail.com> wrote:

> yes,try
> console.baundrate=9600
> but you may have to check if your serial driver has support this

cs0.baudrate=9600

use devinfo to see all available consoles (cs0, cs1 etc).

Also if you use advanced shell then use <tab> key, e.g.

cs<tab>.bau<tab>

> 在 2014-5-14，上午11:34，Fabio Estevam <festevam at gmail.com> 写道：
> 
> > Hi,
> > 
> > I am running barebox on a mx6qsabresd board and would like to know if
> > there is a way to change the serial baudrate via barebox prompt.
> > 
> > Any suggestion?
> > 
> > Thanks,
> > 
> > Fabio Estevam
> > 
> > _______________________________________________
> > barebox mailing list
> > barebox at lists.infradead.org
> > http://lists.infradead.org/mailman/listinfo/barebox
> 
> _______________________________________________
> barebox mailing list
> barebox at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/barebox


-- 
-- 
Best regards,
  Antony Pavlov