[PATCH 4/5] mtd: atmel_nand: retrieve ecc_mode from pdata

[Raphaël Poggi]

By retrieving the ecc_mode from pdata we can use the same code for device tree and
non device tree probing. Which was not possible before, because ecc_mode was arbitrarily set to
NAND_ECC_SOFT.

Signed-off-by: Raphaël Poggi <poggi.raph at gmail.com>
---
 drivers/mtd/nand/atmel_nand.c |    4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/mtd/nand/atmel_nand.c b/drivers/mtd/nand/atmel_nand.c
index eba7125..82bee92 100644
--- a/drivers/mtd/nand/atmel_nand.c
+++ b/drivers/mtd/nand/atmel_nand.c
@@ -1208,7 +1208,7 @@ static int __init atmel_nand_probe(struct device_d *dev)
 		goto err_no_card;
 	}
 	else {
-	    pdata = dev->platform_data;
+	    memcpy(host->board, dev->platform_data, sizeof(struct atmel_nand_data));
 	}
 
 	nand_chip->priv = host;		/* link the private data structures */
@@ -1257,7 +1257,7 @@ static int __init atmel_nand_probe(struct device_d *dev)
 		}
 	}
 
-	nand_chip->ecc.mode = NAND_ECC_SOFT;
+	nand_chip->ecc.mode = pdata->ecc_mode;
 
 	if (IS_ENABLED(CONFIG_NAND_ECC_HW) &&
 	    pdata->ecc_mode == NAND_ECC_HW) {
-- 
1.7.9.5