[PATCH 2/3] ARM: i.mx53: Parse Reset GPIO pin in FEC driver from Devicetree

[Jean-Christophe PLAGNIOL-VILLARD]

On 15:42 Tue 05 Nov     , Rostislav Lisovy wrote:
> Signed-off-by: Rostislav Lisovy <lisovy at gmail.com>
> 
> diff --git a/drivers/net/fec_imx.c b/drivers/net/fec_imx.c
> index 2f31352..6f883bf 100644
> --- a/drivers/net/fec_imx.c
> +++ b/drivers/net/fec_imx.c
> @@ -27,6 +27,8 @@
>  #include <linux/clk.h>
>  #include <linux/err.h>
>  #include <of_net.h>
> +#include <of_gpio.h>
> +#include <gpio.h>
>  
>  #include <asm/mmu.h>
>  
> @@ -643,6 +645,9 @@ static int fec_probe(struct device_d *dev)
>  	void *base;
>  	int ret;
>  	enum fec_type type;
> +#ifdef CONFIG_OFDEVICE
> +	int phy_reset;
> +#endif
>  
>  	ret = dev_get_drvdata(dev, (unsigned long *)&type);
>  	if (ret)
> @@ -671,6 +676,22 @@ static int fec_probe(struct device_d *dev)
>  
>  	fec->regs = dev_request_mem_region(dev, 0);
>  
> +#ifdef CONFIG_OFDEVICE
use if (IS_ENABLED(CONFIG_OFDEVICE))

so we can improve the code coverage
> +	phy_reset = of_get_named_gpio(dev->device_node, "phy-reset-gpios", 0);
> +	if (!gpio_is_valid(phy_reset))
> +		goto err_free;
> +
> +	ret = gpio_request(phy_reset, "phy-reset");
> +	if (ret) {
> +		pr_err("Can not request gpio %d (phy-reset): %d\n", phy_reset, ret);
> +		goto err_free;
> +	}
> +
> +	gpio_direction_output(phy_reset, 0);
you need to check the return too
> +	udelay(10);
> +	gpio_set_value(phy_reset, 1);
> +#endif
> +
>  	/* Reset chip. */
>  	writel(FEC_ECNTRL_RESET, fec->regs + FEC_ECNTRL);
>  	while(readl(fec->regs + FEC_ECNTRL) & 1) {
> -- 
> 1.7.10.4
> 
> 
> _______________________________________________
> barebox mailing list
> barebox at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/barebox