[PATCH 4/5] ppc: DA923RC: add board support

[Renaud Barbier]

On 01/11/2013 11:58, Sascha Hauer wrote:
> On Thu, Oct 31, 2013 at 08:10:28PM +0000, Renaud Barbier wrote:
>> On 31/10/2013 07:48, Sascha Hauer wrote:
>>>>> +
>>>>>>> +	fsl_i2c_init(0, 400000, 0x7f);
>>>>>>> +	/* Read board id from offset 0. */
>>>>>>> +	ret = fsl_i2c_read(i2c, 0x3b, 0, 1, &id, sizeof(uint8_t));
>>>>>>> +	fsl_i2c_stop(i2c);
>>>>>>> +
>>>>>>> +	if (ret == -1) {
>>>>>>> +		/* Enable I2C bus on GBX460. */
>>>>>>> +		out_be16(IOMEM(0xfc010020), 0);
>>>>>>> +		ret = fsl_i2c_read(i2c, 0x3b, 0, 1, &id, sizeof(uint8_t));
>>>>>>> +		fsl_i2c_stop(i2c);
>>>>> why you do not simly use the standdard i2c AP?
>>> I think because the machine is still running from SRAM or flash here and
>>> I2C is needed to read out the SPD EEPROM for setting up SDRAM.
>>>
>>
>> In order to use the I2C API would I not need to register my i2c bus
>> first? This only happens later in the initcall list with device-initcall.
> 
> Yes, You would have to have your i2c bus registered. Can't you move the
> above to late_initcall?
> 
> Sascha
> 

I just did the following experiment:
Move the code to device_initcall after the I2C registration and use the
I2C API. Using the I2C API worked. However, when booting the board model
is a NULL strings.

So next I will check whether I can register the I2C device either in the
postcore_initcall or when doing the console_initcall.

Renaud.