[PATCH v2] nand_base: fix to test for JCPV problem

[Eric Bénard]

Le Wed, 8 May 2013 19:11:32 +0200,
Jean-Christophe PLAGNIOL-VILLARD <plagnioj at jcrosoft.com> a écrit :

> Hi,
> 
> 	same
> 
> barebox 2013.05.0-00119-g57955f2 #613 Thu May 9 01:12:00 CST 2013
> 
> 
> Board: Atmel at91sam9x5-ek
> AT91: Detected soc type: at91sam9x5
> AT91: Detected soc subtype: at91sam9x25
> Clocks: CPU 400 MHz, master 133 MHz, main 12.000 MHz
> netconsole: registered as cs2
> CM: SAM9X25-CM [B2] from RONETIX
> EK: SAM9x5-EK [B0] from FLEX
> DM: SAM9x5-DM [B0] from FLEX
> sn: 0x4010465, rev: 0x10421
> atmel_nand: Use On Flash BBT
> nand: no valid ONFI param page found
> nand: Manufacturer ID: 0xad, Chip ID: 0xda (Hynix NAND 256MiB 3,3V 8-bit), page size: 0, OOB size: 0
> atmel_nand atmel_nand0: Initialize PMECC params, cap: 2, sector: 512
> nand: No oob scheme defined for oobsize 0
> BUG: failure at /opt/work/barebox/drivers/mtd/nand/nand_base.c:1642/nand_scan_tail()!
> BUG!
> no stack data available
> 
behaviour should be different with v3 (I had an error in v2)

Eric