[PATCH] nand_base: fix to test for JCPV problem

[Eric Bénard]

Le Wed, 8 May 2013 18:41:58 +0200,
Jean-Christophe PLAGNIOL-VILLARD <plagnioj at jcrosoft.com> a écrit :

> On 18:20 Wed 08 May     , Eric Bénard wrote:
> > Signed-off-by: Eric Bénard <eric at eukrea.com>
> 
> better but an other BUG
> 
> Board: Atmel at91sam9x5-ek
> AT91: Detected soc type: at91sam9x5
> AT91: Detected soc subtype: at91sam9x25
> Clocks: CPU 400 MHz, master 133 MHz, main 12.000 MHz
> netconsole: registered as cs2
> CM: SAM9X25-CM [B2] from RONETIX
> EK: SAM9x5-EK [B0] from FLEX
> DM: SAM9x5-DM [B0] from FLEX
> sn: 0x4010465, rev: 0x10421
> atmel_nand: Use On Flash BBT
> nand: ONFI flash detected ... nand: no valid ONFI param page found

Ok so your flash has the ONFI string but not the param page, some hynix
have that ... which is quite strange but already handled in the kernel.

> nand: Manufacturer ID: 0xad, Chip ID: 0xda (Hynix NAND 256MiB 3,3V 8-bit), page size: 0, OOB size: 0
> atmel_nand atmel_nand0: Initialize PMECC params, cap: 2, sector: 512
> nand: No oob scheme defined for oobsize 0
> BUG: failure at /opt/work/barebox/drivers/mtd/nand/nand_base.c:1483/nand_scan_tail()!
> BUG!

OK new version sent. Please send me the bootlog again.

thanks,
Eric