[PATCH] ARM: ccmx51: Set PMIC SW1 voltage for i.MX51 less than TO3 only

[Sascha Hauer]

On Thu, Jun 13, 2013 at 11:19:56AM +0400, Alexander Shiyan wrote:
> This settings taken from original DIGI U-boot source code.
> 
> Signed-off-by: Alexander Shiyan <shc_work at mail.ru>

Applied, thanks

Sascha

> ---
>  arch/arm/boards/ccxmx51/ccxmx51.c | 12 ++++++------
>  1 file changed, 6 insertions(+), 6 deletions(-)
> 
> diff --git a/arch/arm/boards/ccxmx51/ccxmx51.c b/arch/arm/boards/ccxmx51/ccxmx51.c
> index 9610e41..b760ca8 100644
> --- a/arch/arm/boards/ccxmx51/ccxmx51.c
> +++ b/arch/arm/boards/ccxmx51/ccxmx51.c
> @@ -256,13 +256,13 @@ static int ccxmx51_power_init(void)
>  	val = 0x238033;
>  	mc13xxx_reg_write(mc13xxx_dev, MC13892_REG_CHARGE, val);
>  
> -	/* Set core voltage (SW1) to 1.1V */
> -	mc13xxx_reg_read(mc13xxx_dev, MC13892_REG_SW_0, &val);
> -	val &= ~0x00001f;
> -	val |=  0x000014;
> -	mc13xxx_reg_write(mc13xxx_dev, MC13892_REG_SW_0, val);
> -
>  	if (imx_silicon_revision() < IMX_CHIP_REV_3_0) {
> +		/* Set core voltage (SW1) to 1.1V */
> +		mc13xxx_reg_read(mc13xxx_dev, MC13892_REG_SW_0, &val);
> +		val &= ~0x00001f;
> +		val |=  0x000014;
> +		mc13xxx_reg_write(mc13xxx_dev, MC13892_REG_SW_0, val);
> +
>  		/* Setup VCC (SW2) to 1.25 */
>  		mc13xxx_reg_read(mc13xxx_dev, MC13892_REG_SW_1, &val);
>  		val &= ~0x00001f;
> -- 
> 1.8.1.5
> 
> 
> _______________________________________________
> barebox mailing list
> barebox at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/barebox
> 

-- 
Pengutronix e.K.                           |                             |
Industrial Linux Solutions                 | http://www.pengutronix.de/  |
Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |