[help] PHY driver : Unable to find a PHY (unknown ID?)

[Eric Bénard]

Hi Mylène,

Le Fri, 4 Jan 2013 13:46:15 +0100,
"Mylene Josserand" <Mylene.Josserand at navocap.com> a écrit :
> I will search deeper in the code the possible problem but if you have an 
> idea of it, do not hesitate !
> 
did you check :
- the pin mux is properly configured for MII operations (on the right
  pins connected to the PHY of course),
- the reset pin is deasserted before probing the PHY,
- the FEC's clock is enabled,

Last thing, if you set phy_addr = -1, then IIRC the PHY address will be
probed automatically.

Best regards,
Eric