[PATCH] mtd: always write page when oob is given

[Sascha Hauer]

Since recently we check for the page being written for not being
empty and do not actually write it when it is. This fails for a
freshly created flash bad block table when all blocks are good.
In this case the bbt code will try to write an empty page, but
with the BBT marker in OOB. This page never gets written, so the
BBT code will not find a bad block table during next start up and
writes it again. Fix this by checking if we want to write OOB data,
if we do, then write the page, even if the data is empty.

Signed-off-by: Sascha Hauer <s.hauer at pengutronix.de>
---
 drivers/mtd/nand/nand_write.c |    2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/mtd/nand/nand_write.c b/drivers/mtd/nand/nand_write.c
index cd8ee06..eea5113 100644
--- a/drivers/mtd/nand/nand_write.c
+++ b/drivers/mtd/nand/nand_write.c
@@ -320,7 +320,7 @@ int nand_do_write_ops(struct mtd_info *mtd, loff_t to,
 			memset(chip->oob_poi, 0xff, mtd->oobsize);
 		}
 
-		if (!mtd_all_ff(wbuf, mtd->writesize)) {
+		if (oob || !mtd_all_ff(wbuf, mtd->writesize)) {
 			ret = chip->write_page(mtd, chip, wbuf, page, cached,
 					       (ops->mode == MTD_OOB_RAW));
 			if (ret)
-- 
1.7.10.4