[PATCH v2 2/2] at91sam9260/9g20ek: remove #ifdef for ek_usb_add_device_mci()

[Fabio Porcedda]

Remove #ifdef for ek_usb_add_device_mci() because there is already
the #ifdef inside at91_add_device_mci(), this way the compiler can check
always the code without any penality.

Signed-off-by: Fabio Porcedda <fabio.porcedda at gmail.com>
Cc: Jean-Christophe PLAGNIOL-VILLARD <plagnioj at jcrosoft.com>
---
 arch/arm/boards/at91sam9260ek/init.c | 4 ----
 1 file changed, 4 deletions(-)

diff --git a/arch/arm/boards/at91sam9260ek/init.c b/arch/arm/boards/at91sam9260ek/init.c
index 5b163b7..ed4f0dd 100644
--- a/arch/arm/boards/at91sam9260ek/init.c
+++ b/arch/arm/boards/at91sam9260ek/init.c
@@ -153,7 +153,6 @@ static void at91sam9260ek_phy_reset(void)
 /*
  * MCI (SD/MMC)
  */
-#if defined(CONFIG_MCI_ATMEL)
 static struct atmel_mci_platform_data __initdata ek_mci_data = {
 	.bus_width	= 4,
 	.slot_b		= 1,
@@ -166,9 +165,6 @@ static void ek_usb_add_device_mci(void)
 
 	at91_add_device_mci(0, &ek_mci_data);
 }
-#else
-static void ek_usb_add_device_mci(void) {}
-#endif
 
 /*
  * USB Host port
-- 
1.8.1.1