[PATCH 1/2] at91sam9260/9g20ek: use IS_ENABLED instead of #if/#ifdef

[Fabio Porcedda]

Using IS_ENABLED instead of #if/#ifdef the compiler can check
all the code.
Using IS_ENABLED for configuring smc->mode is an optimization,
reduce init.o text from 905 to 877.

Signed-off-by: Fabio Porcedda <fabio.porcedda at gmail.com>
Cc: Jean-Christophe PLAGNIOL-VILLARD <plagnioj at jcrosoft.com>
---
 arch/arm/boards/at91sam9260ek/init.c | 19 ++++++++++---------
 1 file changed, 10 insertions(+), 9 deletions(-)

diff --git a/arch/arm/boards/at91sam9260ek/init.c b/arch/arm/boards/at91sam9260ek/init.c
index 06a53f2..bb0025d 100644
--- a/arch/arm/boards/at91sam9260ek/init.c
+++ b/arch/arm/boards/at91sam9260ek/init.c
@@ -37,9 +37,8 @@ static void ek_set_board_type(void)
 {
 	if (machine_is_at91sam9g20ek()) {
 		armlinux_set_architecture(MACH_TYPE_AT91SAM9G20EK);
-#ifdef CONFIG_AT91_HAVE_2MMC
-		armlinux_set_revision(HAVE_2MMC);
-#endif
+		if (IS_ENABLED(CONFIG_AT91_HAVE_2MMC))
+			armlinux_set_revision(HAVE_2MMC);
 	} else {
 		armlinux_set_architecture(MACH_TYPE_AT91SAM9260EK);
 	}
@@ -107,10 +106,12 @@ static void ek_add_device_nand(void)
 		smc = &ek_9260_nand_smc_config;
 
 	/* setup bus-width (8 or 16) */
-	if (nand_pdata.bus_width_16)
+	if (IS_ENABLED(CONFIG_MTD_NAND_ATMEL_BUSWIDTH_16)) {
+		nand_pdata.bus_width_16 = 1;
 		smc->mode |= AT91_SMC_DBW_16;
-	else
+	} else {
 		smc->mode |= AT91_SMC_DBW_8;
+	}
 
 	/* configure chip-select 3 (NAND) */
 	sam9_smc_configure(0, 3, smc);
@@ -209,10 +210,10 @@ static void __init ek_add_led(void)
 {
 	int i;
 
-#ifdef CONFIG_AT91_HAVE_2MMC
-	leds[0].gpio = AT91_PIN_PB8;
-	leds[1].gpio = AT91_PIN_PB9;
-#endif
+	if (IS_ENABLED(CONFIG_AT91_HAVE_2MMC)) {
+		leds[0].gpio = AT91_PIN_PB8;
+		leds[1].gpio = AT91_PIN_PB9;
+	}
 
 	for (i = 0; i < ARRAY_SIZE(leds); i++) {
 		at91_set_gpio_output(leds[i].gpio, leds[i].active_low);
-- 
1.8.1.1