PCM038 USB is broken again

[Alexander Shiyan]

Hello.

USB functionality on PCM038 (PCM970) is broken again due
patch "Revert usb: chipidea-imx: Fix usb initialization".

Board: Phytec phyCORE-i.MX27
detected i.MX27 revision 2.1
netconsole: registered as cs1
mc13xxx-spi mc137830: Found MC13783 ID: 0x00009b [Rev: 3.1]
cfi_flash cfi_flash0: found cfi flash at c0000000, size 33554432
nand: NAND device: Manufacturer ID: 0x20, Chip ID: 0x36 (ST Micro NAND 64MiB 1,8V 8-bit), 64MiB, page size: 512, OOB size: 16
Bad block table found at page 131040, version 0x01
Bad block table found at page 131008, version 0x01
imxfb imxfb: i.MX Framebuffer driver
mdio_bus: miibus0: probed
No ULPI found. vid: 0x0000 pid: 0x0000
pcm038: Using environment in NOR Flash
No ULPI found. vid: 0x0000 pid: 0x0000
imx-usb imx-usb2: USB EHCI 1.00
imx-mmc imx-mmc1: registered as imx-mmc1
running /env/bin/init...

After remove this patch, all works fine.

Board: Phytec phyCORE-i.MX27
detected i.MX27 revision 2.1
netconsole: registered as cs1
mc13xxx-spi mc137830: Found MC13783 ID: 0x00009b [Rev: 3.1]
cfi_flash cfi_flash0: found cfi flash at c0000000, size 33554432
nand: NAND device: Manufacturer ID: 0x20, Chip ID: 0x36 (ST Micro NAND 64MiB 1,8V 8-bit), 64MiB, page size: 512, OOB size: 16
Bad block table found at page 131040, version 0x01
Bad block table found at page 131008, version 0x01
imxfb imxfb: i.MX Framebuffer driver
mdio_bus: miibus0: probed
Found NXP ISP150x ULPI transceiver (0x04cc:0x1504).
pcm038: Using environment in NOR Flash
Found NXP ISP150x ULPI transceiver (0x04cc:0x1504).
imx-usb imx-usb2: USB EHCI 1.00
imx-mmc imx-mmc1: registered as imx-mmc1
running /env/bin/init...

---