[PATCH] ARM: OMAP5 processors support

[menon.nishanth at gmail.com]

Hi,
On Thu, Apr 25, 2013 at 4:09 AM, Uladzimir Bely
<u.bely at sam-solutions.com> wrote:
> Since commit
>         8bafdc1 ARM i.MX28: make chip reset via reset pin work again
>
> Patch adds basic OMAP5 support to barebox.
>
> Tested on SD card with 2 partitions: vfat (MLO, barebox.bin, zImage)
> and ext3 (rootfs). Barebox successfully starts kernel
> from commandline with "bootm /boot/zImage" command.
>
> Building MLO: make omap5_sevm_xload_defconfig; make.
> Building barebox.bin: make omap5_sevm_defconfig; make.
>
> It's an optimized and cleaned up version of previous patch.

Our upstream kernel support will be DT-only :). Further, OMAP5 ES2.0
SEVM does not exist. ES1.0 is few initial samples for development
purposes - there are drastic differences in base addresses etc for
OMAP5 ES2.0.

If providing support for ES2.0, please use uEVM as reference platform.
ES1.0 was meant to be in-development processor - no longer produced
and definitely meant to be replaced with ES2.0.
<snip>
Regards,
Nishanth Menon