[PATCH 1/1] net: introduce phylib
Jean-Christophe PLAGNIOL-VILLARD
plagnioj at jcrosoft.com
Sun Sep 23 13:21:51 EDT 2012
On 16:50 Sun 23 Sep , Sascha Hauer wrote:
> On Sat, Sep 22, 2012 at 12:12:54PM +0200, Jean-Christophe PLAGNIOL-VILLARD wrote:
> > Adapt phylib from linux
> >
> > switch all the driver to it
> > reimplement mii bus
> >
> > This will allow to have
> > - phy drivers
> > - to only connect the phy at then opening of the device
> > - if the phy is not ready or not up fail on open
> >
> > Same behaviour as in linux and will allow to share code and simplify porting.
> >
> > + * get_phy_id - reads the specified addr for its ID.
> > + * @bus: the target MII bus
> > + * @addr: PHY address on the MII bus
> > + * @phy_id: where to store the ID retrieved.
> > + *
> > + * Description: Reads the ID registers of the PHY at @addr on the
> > + * @bus, stores it in @phy_id and returns zero on success.
> > + */
> > +int get_phy_id(struct mii_bus *bus, int addr, u32 *phy_id)
> > +{
> > + int phy_reg;
> > +
> > + /* Grab the bits from PHYIR1, and put them
> > + * in the upper half */
> > + phy_reg = mdiobus_read(bus, addr, MII_PHYSID1);
> > +
> > + io (phy_reg < 0)
> > + return -EIO;
>
> Which gcc version do you use? Mine doesn't understand 'io'
edit patch by mistake when checking it
the tag should be ok
>
> Please also fix this:
>
> config: ppc pcm030_defconfig
> drivers/net/fec_mpc5200.c: In function 'mpc5xxx_fec_probe':
> drivers/net/fec_mpc5200.c:683:8: error: 'RMII' undeclared (first use in this function)
> drivers/net/fec_mpc5200.c:683:8: note: each undeclared identifier is reported only once for each function it appears in
> drivers/net/fec_mpc5200.c:686:8: error: 'RGMII' undeclared (first use inthis function)
> make[2]: *** [drivers/net/fec_mpc5200.o] Error 1
> make[2]: *** Waiting for unfinished jobs....
> make[1]: *** [drivers/net] Error 2
> make[1]: *** Waiting for unfinished jobs....
> make: *** [drivers] Error 2
> make: *** Waiting for unfinished jobs....
this freescale driver is piss me off with it's copy and paste
Best Regards,
J.
More information about the barebox
mailing list