[PATCH] Added SDR-size auto detection.

Sascha Hauer s.hauer at pengutronix.de
Fri Jul 20 03:24:02 EDT 2012


Hi Jürgen,

Applied this series except the hack alert.

Sascha

On Wed, Jul 18, 2012 at 02:58:44PM +0200, Juergen Kilb wrote:
> 
> Signed-off-by: Juergen Kilb <J.Kilb at phytec.de>
> ---
>  arch/arm/boards/phycard-a-l1/pca-a-l1.c |  169 +++++++++++++++++++++++--------
>  1 files changed, 125 insertions(+), 44 deletions(-)
> 
> diff --git a/arch/arm/boards/phycard-a-l1/pca-a-l1.c b/arch/arm/boards/phycard-a-l1/pca-a-l1.c
> index a388f63..1dc7678 100644
> --- a/arch/arm/boards/phycard-a-l1/pca-a-l1.c
> +++ b/arch/arm/boards/phycard-a-l1/pca-a-l1.c
> @@ -73,10 +73,82 @@
>  
>  #define SMC911X_BASE 0x2c000000
>  
> +/* Slower full frequency range default timings for x32 operation */
> +#define SDP_SDRC_SHARING	0x00000100
> +/* Diabling power down mode using CKE pin */
> +#define SDP_SDRC_POWER_POP	0x00000081
> +/* rkw - need to find of 90/72 degree recommendation for speed like before. */
> +#define SDP_SDRC_DLLAB_CTRL ((DLL_ENADLL << 3) | \
> +	(DLL_LOCKDLL << 2) | (DLL_DLLPHASE_90 << 1))
> +
> +/* used to create an array of memory configuartions. */
> +struct sdrc_config {
> +	u32	cs_cfg;
> +	u32	mcfg;
> +	u32	mr;
> +	u32	actim_ctrla;
> +	u32	actim_ctrlb;
> +	u32	rfr_ctrl;
> +} const sdrc_config[] = {
> +/* max cs_size for autodetection, common timing */
> +/* 2x256MByte, 14 Rows, 10 Columns , RBC (BAL=2) */
> +{ 0x00000004, 0x03590099, 0x00000032, 0x9A9DB4C6, 0x00011216, 0x0004e201},
> +/* MT46H32M32LF 2x128MByte, 13 Rows, 10 Columns */
> +{ 0x00000001, 0x02584099, 0x00000032, 0x9A9DB4C6, 0x00011216, 0x0004e201},
> +/* MT46H64M32LF 1x256MByte, 14 Rows, 10 Columns */
> +{ 0x00000002, 0x03588099, 0x00000032, 0x629DB4C6, 0x00011113, 0x0004e201},
> +/* MT64H128M32L2 2x256MByte, 14 Rows, 10 Columns */
> +{ 0x00000002, 0x03588099, 0x00000032, 0x629DB4C6, 0x00011113, 0x0004e201},
> +};
> +
>  /*
>   * Boot-time initialization(s)
>   */
>  
> +/*********************************************************************
> + * init_sdram_ddr() - Init DDR controller.
> + *********************************************************************/
> +void init_sdram_ddr(void)
> +{
> +	/* reset sdrc controller */
> +	writel(SOFTRESET, SDRC_REG(SYSCONFIG));
> +	wait_on_value(1<<0, 1<<0, SDRC_REG(STATUS), 12000000);
> +	writel(0, SDRC_REG(SYSCONFIG));
> +
> +	/* setup sdrc to ball mux */
> +	writel(SDP_SDRC_SHARING, SDRC_REG(SHARING));
> +	writel(SDP_SDRC_POWER_POP, SDRC_REG(POWER));
> +
> +	/* set up dll */
> +	writel(SDP_SDRC_DLLAB_CTRL, SDRC_REG(DLLA_CTRL));
> +	sdelay(0x2000);	/* give time to lock */
> +
> +}
> +/*********************************************************************
> + * config_sdram_ddr() - Init DDR on dev board.
> + *********************************************************************/
> +void config_sdram_ddr(u8 cs, u8 cfg)
> +{
> +
> +	writel(sdrc_config[cfg].mcfg, SDRC_REG(MCFG_0) + (0x30 * cs));
> +	writel(sdrc_config[cfg].actim_ctrla, SDRC_REG(ACTIM_CTRLA_0) + (0x28 * cs));
> +	writel(sdrc_config[cfg].actim_ctrlb, SDRC_REG(ACTIM_CTRLB_0) + (0x28 * cs));
> +	writel(sdrc_config[cfg].rfr_ctrl, SDRC_REG(RFR_CTRL_0) + (0x30 * cs));
> +
> +	writel(CMD_NOP, SDRC_REG(MANUAL_0) + (0x30 * cs));
> +
> +	sdelay(5000);
> +
> +	writel(CMD_PRECHARGE, SDRC_REG(MANUAL_0) + (0x30 * cs));
> +	writel(CMD_AUTOREFRESH, SDRC_REG(MANUAL_0) + (0x30 * cs));
> +	writel(CMD_AUTOREFRESH, SDRC_REG(MANUAL_0) + (0x30 * cs));
> +
> +	/* set mr0 */
> +	writel(sdrc_config[cfg].mr, SDRC_REG(MR_0) + (0x30 * cs));
> +
> +	sdelay(2000);
> +}
> +
>  /**
>   * @brief Initialize the SDRC module
>   * Initialisation for 1x256MByte but normally
> @@ -85,49 +157,55 @@
>   */
>  static void pcaal1_sdrc_init(void)
>  {
> -	/* SDRAM software reset */
> -	/* No idle ack and RESET enable */
> -	writel(0x1A, SDRC_REG(SYSCONFIG));
> -	sdelay(100);
> -	/* No idle ack and RESET disable */
> -	writel(0x18, SDRC_REG(SYSCONFIG));
> -
> -	/* SDRC Sharing register */
> -	/* 32-bit SDRAM on data lane [31:0] - CS0 */
> -	/* pin tri-stated = 1 */
> -	writel(0x00000100, SDRC_REG(SHARING));
> -
> -	/* ----- SDRC Registers Configuration --------- */
> -	/* SDRC_MCFG0 register */
> -	writel(0x03588099, SDRC_REG(MCFG_0));
> -
> -	/* SDRC_RFR_CTRL0 register */
> -	writel(0x0004e201, SDRC_REG(RFR_CTRL_0));
> -
> -	/* SDRC_ACTIM_CTRLA0 register */
> -	writel(0x629DB4C6, SDRC_REG(ACTIM_CTRLA_0));
> -
> -	/* SDRC_ACTIM_CTRLB0 register */
> -	writel(0x00011113, SDRC_REG(ACTIM_CTRLB_0));
> -
> -	/* Disble Power Down of CKE due to 1 CKE on combo part */
> -	writel(0x00000081, SDRC_REG(POWER));
> -
> -	/* SDRC_MANUAL command register */
> -	/* NOP command */
> -	writel(0x00000000, SDRC_REG(MANUAL_0));
> -	/* Precharge command */
> -	writel(0x00000001, SDRC_REG(MANUAL_0));
> -	/* Auto-refresh command */
> -	writel(0x00000002, SDRC_REG(MANUAL_0));
> -	/* Auto-refresh command */
> -	writel(0x00000002, SDRC_REG(MANUAL_0));
> -
> -	/* SDRC MR0 register Burst length=4 */
> -	writel(0x00000032, SDRC_REG(MR_0));
> -
> -	/* SDRC DLLA control register */
> -	writel(0x0000000A, SDRC_REG(DLLA_CTRL));
> +	u32 test0, test1;
> +	char cfg;
> +
> +	init_sdram_ddr();
> +
> +	config_sdram_ddr(0, 0); /* 256MByte at CS0 */
> +	config_sdram_ddr(1, 0); /* 256MByte at CS1 */
> +
> +	test0 = get_ram_size((long *) 0x80000000, SZ_256M);
> +	test1 = get_ram_size((long *) 0xA0000000, SZ_256M);
> +
> +	/* mask out lower nible, its not tested with
> +	in common/memsize.c */
> +	test1 &= 0xfffffff0;
> +
> +	if ((test1 > 0) && (test1 != test0))
> +		hang();
> +
> +	cfg = -1; /* illegal configuration found */
> +
> +	if (test1 == 0) {
> +		init_sdram_ddr();
> +		writel((sdrc_config[(uchar) cfg].mcfg & 0xfffc00ff), SDRC_REG(MCFG_1));
> +
> +		/* 1 x 256MByte */
> +		if (test0 == SZ_256M)
> +			cfg = 2;
> +
> +		if (cfg != -1) {
> +			config_sdram_ddr(0, cfg);
> +			writel(sdrc_config[(uchar) cfg].cs_cfg, SDRC_REG(CS_CFG));
> +		}
> +		return;
> +	}
> +
> +	/* reinit both cs with correct size */
> +	/* 2 x 128MByte */
> +	if (test0 == SZ_128M)
> +		cfg = 1;
> +	/* 2 x 256MByte */
> +	if (test0 == SZ_256M)
> +		cfg = 3;
> +
> +	if (cfg != -1) {
> +		init_sdram_ddr();
> +		writel(sdrc_config[(uchar) cfg].cs_cfg, SDRC_REG(CS_CFG));
> +		config_sdram_ddr(0, cfg);
> +		config_sdram_ddr(1, cfg);
> +	}
>  }
>  
>  /**
> @@ -296,9 +374,12 @@ static int pcaal1_mem_init(void)
>  				   IORESOURCE_MEM_WRITEABLE);
>  
>  	arm_add_mem_device("ram0", OMAP_SDRC_CS0, get_sdr_cs_size(SDRC_CS0_OSET));
> +	printf("found %s at SDCS0\n", size_human_readable(get_sdr_cs_size(SDRC_CS0_OSET)));
>  
> -	if ((get_sdr_cs_size(SDRC_CS1_OSET) != 0) && (get_sdr_cs1_base() != OMAP_SDRC_CS0))
> +	if ((get_sdr_cs_size(SDRC_CS1_OSET) != 0) && (get_sdr_cs1_base() != OMAP_SDRC_CS0)) {
>  		arm_add_mem_device("ram1", get_sdr_cs1_base(), get_sdr_cs_size(SDRC_CS1_OSET));
> +		printf("found %s at SDCS1\n", size_human_readable(get_sdr_cs_size(SDRC_CS1_OSET)));
> +	}
>  
>  	return 0;
>  }
> -- 
> 1.7.0.4
> 
> 

-- 
Pengutronix e.K.                           |                             |
Industrial Linux Solutions                 | http://www.pengutronix.de/  |
Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |



More information about the barebox mailing list