[PATCH] imx(25,35): save boot location into $barebox_loc env.

[Jean-Christophe PLAGNIOL-VILLARD]

> + */
> +
> +#include <common.h>
> +#include <environment.h>
> +#include <init.h>
> +
> +#include <asm/io.h>
> +#include <mach/imx-regs.h>
> +
> +#if defined(CONFIG_ARCH_IMX25) || defined(CONFIG_ARCH_IMX35)
please move this to the Makefile
> +/*
> + * Saves the boot source media into the $barebox_loc enviroment variable
> + *
> + * This information is useful for barebox init scripts as we can then easily
> + * use a kernel image stored on the same media that we launch barebox with
> + * (for example).
> + *
> + * imx25 and imx35 can boot into barebox from several media such as
> + * nand, nor, mmc/sd cards, serial roms. "mmc" is used to represent several
> + * sources as its impossible to distinguish between them.
> + *
> + * Some sources such as serial roms can themselves have 3 different boot
> + * possibilities (i2c1, i2c2 etc). It is assumed that any board will
> + * only be using one of these at any one time.
> + *
> + * Note also that I suspect that the boot source pins are only sampled at
> + * power up.
> + */
> +static int imx_boot_save_loc(void)
> +{
> +	const char *bareboxloc = NULL;
> +	uint32_t reg;
> +	unsigned int ctrl, type;
> +
> +	/* [CTRL][TYPE] */
> +	const char *const locations[4][4] = {
	a struct could be better not sure
> +		{ /* CTRL = WEIM */
> +			"nor",
> +			0,
			NULL no?
> +			"onenand",
> +			0
> +		}, { /* CTRL == NAND */
> +			"nand",
> +			"nand",
> +			"nand",
> +			"nand",
> +		}, { /* CTRL == ATA, (imx35 only) */
> +			0,
> +			0, /* might be p-ata */
> +			0,
> +			0,
> +		}, { /* CTRL == expansion */
> +			"mmc", /* note imx25 could also be: movinand, ce-ata */
> +			0,
> +			"i2c",
> +			"spi",
> +		}
> +	};
otherwise look good

Best Regards,
J.