[PATCH 03/10] ARM Chumby: Fix unit of the clocks after the change to Hz

[Juergen Beisert]

With the change to Hz as the main clock unit on the STM architecture the
Chumby must also use this unit.

Signed-off-by: Juergen Beisert <jbe at pengutronix.de>
---
 arch/arm/boards/chumby_falconwing/falconwing.c |    4 ++--
 1 files changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/arm/boards/chumby_falconwing/falconwing.c b/arch/arm/boards/chumby_falconwing/falconwing.c
index e0706f8..10fbba8 100644
--- a/arch/arm/boards/chumby_falconwing/falconwing.c
+++ b/arch/arm/boards/chumby_falconwing/falconwing.c
@@ -266,9 +266,9 @@ static int falconwing_devices_init(void)
 		imx_gpio_mode(pad_setup[i]);
 
 	register_device(&sdram_dev);
-	imx_set_ioclk(480U * 1000U);	/* enable IOCLK to run at the PLL frequency */
+	imx_set_ioclk(480000000); /* enable IOCLK to run at the PLL frequency */
 	/* run the SSP unit clock at 100,000 kHz */
-	imx_set_sspclk(0, 100U * 1000U, 1);
+	imx_set_sspclk(0, 100000000, 1);
 	register_device(&mci_dev);
 
 	armlinux_add_dram(&sdram_dev);
-- 
1.7.2.3