problem with b43
Gábor Stefanik
netrolller.3d at gmail.com
Fri Sep 24 13:06:17 EDT 2010
On Fri, Sep 24, 2010 at 6:55 PM, Cyrille <cyrille at cbiot.fr> wrote:
> Hi
> I've got a problem with a broadcom 4312 [12e4:4315].
> The environment :
> ===========================
> uname -a
> 2.6.35.5-libre.29.fc14.x86_64
>
> lspci -vnn
> 0b:00.0 Network controller [0280]: Broadcom Corporation BCM4312 802.11b/g [14e4:4315] (rev 01)
> Subsystem: Dell Wireless 1395 WLAN Mini-Card [1028:000b]
> Flags: bus master, fast devsel, latency 0, IRQ 17
> Memory at fe7fc000 (64-bit, non-prefetchable) [size=16K]
> Capabilities: [40] Power Management version 3
> Capabilities: [58] Vendor Specific Information: Len=78 <?>
> Capabilities: [e8] MSI: Enable- Count=1/1 Maskable- 64bit+
> Capabilities: [d0] Express Endpoint, MSI 00
> Capabilities: [100] Advanced Error Reporting
> Capabilities: [13c] Virtual Channel
> Capabilities: [160] Device Serial Number 7f-78-4e-ff-ff-6d-00-23
> Capabilities: [16c] Power Budgeting <?>
> Kernel driver in use: b43-pci-bridge
> Kernel modules: ssb
> ===============================
>
> Installation method ( http://wireless.kernel.org/en/users/Drivers/b43#fw-b43-lp ) :
> You are using the b43 driver from linux-2.6.25 or newer
> export FIRMWARE_INSTALL_DIR="/lib/firmware"
> wget http://mirror2.openwrt.org/sources/broadcom-wl-4.150.10.5.tar.bz2
> tar xjf broadcom-wl-4.150.10.5.tar.bz2
> cd broadcom-wl-4.150.10.5/driver
> sudo ../../b43-fwcutter-013/b43-fwcutter -w "$FIRMWARE_INSTALL_DIR" wl_apsta_mimo.o
You are using the firmware for G-PHYs. Yo should use v4.174 (also
known as v4.178) for LP-PHY.
>
>
> Seems work : ls /lib/firmware/b43-open/
> a0g0bsinitvals5.fw a0g1bsinitvals9.fw b0g0bsinitvals9.fw lp0bsinitvals15.fw n0initvals11.fw ucode5.fw
> a0g0bsinitvals9.fw a0g1initvals13.fw b0g0initvals13.fw lp0initvals13.fw pcm5.fw ucode9.fw
> a0g0initvals5.fw a0g1initvals5.fw b0g0initvals5.fw lp0initvals14.fw ucode11.fw
> a0g0initvals9.fw a0g1initvals9.fw b0g0initvals9.fw lp0initvals15.fw ucode13.fw
> a0g1bsinitvals13.fw b0g0bsinitvals13.fw lp0bsinitvals13.fw n0absinitvals11.fw ucode14.fw
> a0g1bsinitvals5.fw b0g0bsinitvals5.fw lp0bsinitvals14.fw n0bsinitvals11.fw ucode15.fw
Extract to /lib/firmware/b43. /lib/firmware/b43-open is only for OpenFWWF.
>
>
> But :
> dmesg
> b43-phy3 ERROR: You must go to http://wireless.kernel.org/en/users/Drivers/b43#devicefirmware and download the correct firmware for this driver version. Please carefully read all instructions on this website.
> b43-phy4: Broadcom 4312 WLAN found (core revision 15)
> b43-phy4 debug: Found PHY: Analog 6, Type 5, Revision 1
> b43-phy4 debug: Found Radio: Manuf 0x17F, Version 0x2062, Revision 2
> phy4: Selected rate control algorithm 'minstrel'
> Registered led device: b43-phy4::tx
> Registered led device: b43-phy4::rx
> Registered led device: b43-phy4::radio
> Broadcom 43xx driver loaded [ Features: PMLS, Firmware-ID: FW13 ]
> ssb0:0: Missing Free firmware
> b43-phy4 ERROR: Rejected non-Free firmware
> ssb0:0: Missing Free firmware
> b43-phy4 ERROR: Rejected non-Free firmware
Compile compat-wireless to bypass the "free-only" patch in Fedora.
(John, are you still maintaining the Fedora kernel's wireless part? If
so, please kill this "freedom enforcement"!)
>
>
> So don't work.
> Grrrrrrrrrrrrrrrrrrrr
> I thought nevertheless that with this kernel that was going to work.
> No idea, I thing is due of the model [12e4:4315]. Is there anyone who can say to me if it possible to install and configure this card with a free-kernel.
>
> Thanx !
>
> Cyrille
>
>
>
> ----
> [ cyrille at cbiot.fr | http://cbiot.fr ]
>
> "Et le combat cessa faute de combattants."
> --- Le Cid (1636), IV, 3, Rodrigue - - - -
>
> BLAG : http://blagblagblag.org
> Blag'em up! http://zenblagger.org
>
>
>
> _______________________________________________
> b43-dev mailing list
> b43-dev at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/b43-dev
>
--
Vista: [V]iruses, [I]ntruders, [S]pyware, [T]rojans and [A]dware. :-)
More information about the b43-dev
mailing list