How to check debug message from adf_os_print()?
Oleksij Rempel
linux at rempel-privat.de
Wed Jan 22 09:14:32 EST 2014
Am 22.01.2014 14:51, schrieb Matteo Danieletto:
> Thanks Oleksij,
>
> I soldered 49th how suggested in wikidevi, I modified the firmware adding adf_os_print.
> When I opened minicom I set upped the serial port (ttyUSB0) with 19200 baudrate.
>
> However I didn’t see any output. So I read the data sheet and I found some different how reported in wikiDevi.
> In wikidevi the 49th pin is GPIO8 instead in data sheet is GPIO10. The 21st pin is the GPIO8 -General purpose and multiplexed serial input data from an SPI device-.
>
> BTW,I was watching the solder made by Oleksij and I recognized that the chipset is ar7010 and the pin was 48th pin (GPIO8)
>
> Do I solder the 21st for my a r9721?
Here is one example:
http://wikidevi.com/w/images/0/07/ALFA_Network_AWUS036NHA_board_top_nonscan.jpg
There are test points RXD1 (pin 49), and TXD1 (pin 48). Normally it
should be written from chips point of view. You need to use pin 48.
--
Regards,
Oleksij
-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 295 bytes
Desc: OpenPGP digital signature
URL: <http://lists.infradead.org/pipermail/ath9k_htc_fw/attachments/20140122/599cccb3/attachment.sig>
More information about the ath9k_htc_fw
mailing list